IMPORTANT SAFETY INSTRUCTIONS Please keep this instruction manual in a safe place, along with your warranty card, purchase receipt and carton for future reference. These safety precautions reduce the risk of fire, electric shock and injury when correctly applied. • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person...
Page 3
• If the power cord is damaged,it must be replaced by the appointed service agent or a similarly qualified person in order to avoid a hazard. • Attention: DO NOT USE THIS HAIR CLIPPER CONTINUOUSLY FOR MORE THAN 10 MINUTES. •...
Page 4
CHARGING YOUR SHAVER Blade Alignment • Your clippers were carefully examined to ensure that the blades were oiled and aligned before leaving our factory. • Blades must be realigned if they have been removed for cleaning or replacement. • To realign the blades, simply match the upper and bottom blades teeth up - point for point.
Page 5
you the closest cut and leave the hair very short. Pushing the lever downward gradually increases the cutting length. • In it’s lowest position, the lever will leave the hair approximately the same length as a # 1 comb. • The lever will also extend the use of your blades since different cutting edge is used in each setting.
Page 6
• Cutting hair requires practice so it is always better to leave the hair longer for the first few haircuts until you become used to the length to which each comb attachment cuts the hair. Attachment Comb • Attachment Comb #0.5 leaves 3mm (1/8 inch) hair length. •...
Page 7
STEP 2 – BACK OF THE HEAD • Change to the next longest comb attachment 7 mm or 9 mm and cut the back of the head (see diagram 2). STEP 3 – SIDE OF THE HEAD • Change to one of the shorter combs 3 mm or 5 mm, trim sideburns, the hair directly in front of the ears.
Page 8
Comb hair and check for uneven areas and outlining neckline as described previously. Distributed by Tempo (Aust) Pty Ltd ABN 70 106 100 252 PO Box 6056, Frenchs Forest DC, Australia NSW 2086 Customer Help Line : 1300 886 649 (AU) | 0800 836 761 (NZ) Telephone: (02) 9975 2199 Fax: (02) 9975 2688 Email: info@tempoaustralia.com.au...
Need help?
Do you have a question about the PR-999 and is the answer not in the manual?
Questions and answers