Hyundai Elantra Quick Reference Manual page 18

FeatUres and COntrOLs
rearVIeW CaMera
Rearview display
CHIlD-prOteCtOr rear DOOr lOCK
32
The rearview camera will activate
when the ignition switch is turned
ON and the shift lever is in the R
(Reverse) position.
Insert a key into the hole and
turn it to the following positions:
Lock ( )
Only allows opening the
rear door handle from
outside of the vehicle.
Unlock ( )
Allows opening the rear
door handle from inside
and outside the vehicle.
HyUNDAI
tIre MObIlItY KIt
ELANTRA
Setup
1. Remove the speed restriction label
from the sealant bottle and place it on
the center of the steering wheel.
2. Ensure that the compressor is
switched to OFF.
3. Lift the cable cover and screw the
compressor hose on to the
connector of the sealant bottle.
4. Insert the sealant bottle into the
housing slot of the compressor.
5. Screw the filling hose of the sealant
bottle onto the tire's valve stem.
6. Insert the compressor power plug
into the vehicle's power outlet.
7. Turn the ignition switch to the ON
position or press the Engine Start/Stop
button twice.
Inflate Tire
1. Switch ON the compressor and let it
run for approximately 5 minutes.
2. Switch OFF the compressor and check
to ensure that inflation pressure is over
32 psi. If not, the puncture is too large
to repair. Contact Hyundai Roadside
Assistance.
3. Remove the filling hose ,
compressor hose ,
and compressor power plug
continued on next page...
.
lll
33