Summary of Contents for Site SMA900
- Page 1 INSTRUCTION MANUAL Angle Grinder SMA900 008475 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
Uncertainty (K) : 1.5 m/s 2002/96/EC on waste electric and ENH501-1 Declaration of Conformity electronic equipment Site UK Ltd implementation in accordance with BA 22 8RT national law, electric equipment that have reached the end of their life must be collected separately and returned to... -
Page 3: General Power Tool Safety Warnings
Do not use a power tool while you are tired or Peter Harries under the influence of drugs, alcohol or Site UK Ltd medication. A moment of inattention while Quality Manager operating power tools may result in serious GEA005-1 personal injury. -
Page 4: Specific Safety Rules
with the power tool or these instructions to The rated speed of the accessory must be at operate the power tool. Power tools are least equal to the maximum speed marked on dangerous in the hands of untrained users. the power tool. Accessories running faster than 21. - Page 5 cut or snagged and your hand or arm may be sharp edges etc. Avoid bouncing and snagging pulled into the spinning accessory. the accessory. Corners, sharp edges or bouncing 13. Never lay the power tool down until the have a tendency to snag the rotating accessory accessory has come to a complete stop.
- Page 6 occur. Investigate and take corrective action to 29. Do not leave the tool running. Operate the tool eliminate the cause of wheel binding only when hand-held. d) Do not restart the cutting operation in the 30. Do not touch the workpiece immediately after workpiece.
-
Page 7: Functional Description
FUNCTIONAL DESCRIPTION Installing side grip CAUTION: Always be sure that the tool is switched off and • unplugged before adjusting or checking function on the tool. Shaft lock 1. Press 008473 CAUTION: Always be sure that the side grip is installed •... -
Page 8: Maintenance
MAINTENANCE To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench CAUTION: and securely tighten clockwise. Always be sure that the tool is switched off and • unplugged before carrying out any work on the 1. - Page 9 GUARANTEE This SITE product carries a guarantee of 12 months. If your product develops a fault within this period, you should, in the first instance contact your retailer. This guarantee specifically excludes losses caused due to: - Fair wear and tear...
- Page 12 Site (UK) Ltd 884766-224...
Need help?
Do you have a question about the SMA900 and is the answer not in the manual?
Questions and answers