1. Manuals
  2. Brands
  3. DeWalt Manuals
  4. Sander
  5. DW849-XE
  6. Instruction manual

DeWalt DW849-XE Instruction Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

INSTRUCTION MANUAL
DW849-XE
POLISHER

Advertisement

Table of Contents
loading

Related Manuals for DeWalt DW849-XE

Summary of Contents for DeWalt DW849-XE

  • Page 1 INSTRUCTION MANUAL DW849-XE POLISHER...

  • Page 3: Definitions: Safety Guidelines

    b. Do not operate power tools in explosive atmospheres, such as in the Definitions: Safety Guidelines presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. The definitions below describe the level of severity for each c.

  • Page 4: Electrical Safety

    under the influence of drugs, alcohol or medication. A moment of inattention operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. while operating power tools may result in serious personal injury. f.

  • Page 5: Double Insulation

    DOUBLE INSULATION g. Do not use a damaged accessory. Before each use inspect the accessory such as backing pad for cracks, tear or excess wear. If power tool or Your unit is double insulated to permit use on non-grounded circuits. This means that accessory is dropped, inspect for damage or install an undamaged it is constructed throughout with two separate layers of electrical insulation between accessory.

  • Page 6: Kickback And Related Warnings

    o. Do not operate the power tool near flammable materials. Sparks could ignite and spinning attachment strings can entangle your fingers or snag on the these materials. workpiece. p. Do not use accessories that require liquid coolants. Using water or other liquid WARNING: ALWAYS use safety glasses.
  • Page 7 • The label on your tool may include the following symbols. The symbols and their OPERATION definitions are as follows: WARNING: Shock Hazard. To reduce the risk of serious personal injury, turn V ....volts A ....amperes tool off and disconnect tool from power source before making any adjustments or Hz ....
  • Page 8 2400 RPM, the tool slows down to about 2000 RPM under a polishing load. Your DW849-XE will continue to run at 2400 RPM (or any speed you select with the control WARNING: TIED KNOT AND ALL STRINGS MUST BE wheel) as a load is applied.

  • Page 9: Motor Brushes

    POLISHING Attaching and Removing Abrasive FIGURE 7 Discs (Figure 7) These instructions and suggestions are intended to familiarise new operators in overall general operation of power polishing. You will develop your own techniques To attach the sanding disc, push the hub of the clamp which will make the job easier and faster as you learn power polishing.

  • Page 10: Maintenance

    MAINTENANCE Guarantee Applicable to hand held Power Tools, Lasers and Nailers. WARNING: Shock Hazard. To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or Three Year Limited Warranty removing/installing attachments or accessories.
  • Page 11 FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call (AUS) 1800 654 155 or (NZ) 09 579 7600 for a free replacement.
  • Page 12 WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 • 20 Fletcher Road, Mooroolbark, VIC 3138 Australia (JAN07) Form No. 650523-00 DW849-XE Copyright © 2007 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme; the “D” shaped air intake grill; the array of pyramids on the handgrip; the kit...

Table of Contents