SeaWorthy SEA9526 Owner's Manual

Marine audio system

Advertisement

,
OWNER S MANUAL
Marine Audio System
PWR
VOL-
PUSH/SEL
VOL+
MUT
DSP
MODE
1 PAU
2 INT
3 RPT
DIRECT-IN PLAY POWER LOADING
TOP/REPEAT/RANDOM/SCAN
3-BEAMLASER TRACKING SYSTEM
DUAL 1-BIT D/A CONVERTERS
24 AM/FM PRESET STATIONS
SEEK UP/DOWN
PRESET SCAN AND AUTO SEARCH
AM/FM/MPX WITH
SINGLE CD PLAYER
SEA9526
SCAN
BND/LD
AS/PS
OPEN
4 RDM
5
6
CLK
MONO
COMPACT
RCA LINE OUT
RCA LINE OUT
DIGITAL AUDIO

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SEA9526 and is the answer not in the manual?

Questions and answers

Nancy Loudon
April 8, 2025

would it be the same manual for the sea9525w 160 watts

Summary of Contents for SeaWorthy SEA9526

  • Page 1 SEA9526 OWNER S MANUAL Marine Audio System VOL- SCAN PUSH/SEL BND/LD VOL+ AS/PS OPEN MODE 1 PAU 2 INT 3 RPT 4 RDM MONO DIRECT-IN PLAY POWER LOADING TOP/REPEAT/RANDOM/SCAN 3-BEAMLASER TRACKING SYSTEM DUAL 1-BIT D/A CONVERTERS 24 AM/FM PRESET STATIONS...
  • Page 2: Specifications

    SPECIFICATIONS CONTENTS Contents.....................1 CD PLAYER Signal / Noise Ratio ........... > 65 dB Installation..................2 Frequency Response ........ 20 Hz~20KHz Channel Separation ..........> 62 dB Installation and removing the unit........
  • Page 4: Radio Operation

    RADIO OPERATION INSTALLATION AND REMOVING THE UNIT Removing the unit RADIO BAND SCAN BND/LD Press the BD/LD button to operate the radio function. There are 3 sets total for FM band (FM1, FM2, FM3) AS/PS There is 1 set AM band (MW) Front Panel Up to 6 preset stations can be stored for each set.
  • Page 5: Basic Operation

    USING THE DETACHABLE FRONT PANEL BASIC OPERATION To Detach the Front Panel: To Reinstall the Front Panel: POWER ON/OFF VOLUME 1. Press the OPEN button, 1. When the panel bracket is in slide down the front panel will slide down. position, insert the front panel into the Press the power button to To adjust volume level,...
  • Page 6: Wiring Diagram

    FUNCTIONS WIRING DIAGRAM Follow this easy wiring diagram to install new or existing Radio and Speaker Wiring System. Warning: This unit is designed for use with 4 speakers; however, it can be installed using only 2 speakers. If installing 2 speakers, do not connect front and rear speaker leads together. Use either the front or rear leads insulating the unused wires.

Table of Contents