Download Print this page

Radica Games Pro Racer RC71106 Instruction Manual page 2

Gamester wheel & pad in one

Advertisement

INTRODUCTION
Congratulations on choosing the Gamester Pro
Racer, the ultimate hand-held racing wheel for
the Nintendo GameCube video game system.
CONTENTS
1 x Pro Racer
1 x Instruction Manual
IMPORTANT
Before using this product, read the GameCube
Instruction Manual for safety, health and other
information.
PRODUCT FEATURES
1. Steering wheel offering eight-bit analog
control.
2. Left analog thumbstick.
3. Right analog C (camera) stick.
4. Five action buttons (A, B, X, Y, and Z).
5. Two triggers (L and R) offering eight-bit
analog control.
6. One vibration feedback motor.
7. One eight-way digital directional pad.
8. One digital menu navigation button
(Start/Pause).
9. One steering wheel locking ring.
2
8
3
1
9
7
5
5
LOCKING RING
The locking ring allows your Gamester Pro
Racer to act both as a wheel and a full-featured
gamepad. When unlocked, the left side of the
Pro Racer will work as a steering mechanism for
all of your favorite driving games, and the left
analog stick will be disabled. When locked, the
steering mechanism will not move, and the left
analog stick will be enabled.
4
TROUBLE SHOOTING
The Pro Racer is not working.
• Make sure the connector plug is firmly
connected to the GameCube controller port.
• Check the locking ring and make sure it is in
the proper position.
• Reset your GameCube console. Note: Do not
use the Analog stick, Camera stick, Left trigger
and Right trigger while turning on GameCube
or it will not be calibrated properly.
MAINTENANCE
• Handle this product carefully.
• Store this product away from dusty or dirty
areas.
• Keep this product away from moisture or
extreme temperature.
• Do not disassemble this product. If problems
persist, consult the Warranty information
located at the end of this Instruction Manual.
Please retain this for future reference.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
WARNING: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate

Advertisement

loading