Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Teltonica GH1202
Summary of Contents for Teltonica GH1202
- Page 1 Handheld GPS/GSM Tracker GH1202 Quick-Start User Manual v.2.24...
-
Page 2: Quick Start Guide
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 QUICK START GUIDE 1 – Microphone 2 – USB connector 3 – Lock switch for the keyboard 4 – Speaker 5 – Keyboard 6 – Indicators 7 – Reset Button Insert SIM card... -
Page 3: Table Of Contents
Charging the battery Installing software Connecting to a PC TRACK ASSISTANT SOFTWARE Track assistant configuration tool Configuration of gh1202 using a PC PIN code Notification about battery level Special SMS Requests TRACK ASSISTANT MONITORING TOOL Monitoring GH1202 when using PC... -
Page 4: Preface
PREFACE INTRODUCTION GH1202 is a device with built-in functions characteristic of a mobile phone and an integrated GPS receiver. This device is intended for the surveillance and protection of people, cargo and objects. The GPS receiver may define the current location of the device and sends this data to a person in charge or the operation centre. -
Page 5: For Your Safety
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 FOR YOUR SAFETY Please read these basic explanations. In disregarding them you may face danger or trespassing of existing laws. In case you wish to have more information, please read the concise user manual. - Page 6 It is recommended to deliver the device to a repair centre or back to the factory. Power supply chains available at a place used for connecting GH1202 must have safety devices (automatic bipolar switch off devices) which protect from power supply excess, short circuit and failure of grounding.
-
Page 7: General Information
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 GENERAL INFORMATION PACKAGE CONTENT GH1202 is supplied to the client packed in a cardboard box with all supplements that are necessary for operation. The set consists of: Handheld GPS/GSM Tracker GH1202 Li-Ion 1050mAh battery 3.7V USB –... -
Page 8: Specifications Of The Device
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 SPECIFICATIONS OF THE DEVICE General GPS receiver SiRF Star III 20 channels Internal GPS antenna Patch External GPS antenna GSM frequencies (MHz) 900/1800 and 850/1900 Voice calls Vibro Keyboard Lock for keyboard Battery... -
Page 9: Electronic Specifications
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 ELECTRONIC SPECIFICATIONS PARMETER Min. Norm. Max. Supply voltage (DC) 4.5V 5.5V Use of electric current 360mA 2500mA (10ms) Battery voltage (DC) 3.7V 4.2V Charger voltage (DC) 4.5V 5.5V Charger electric current 600mA 1000mA... -
Page 10: Getting Started
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 GETTING STARTED INSERTING SIM CARD AND BATTERY All SIM cards must be kept in a save place. You may request your SIM card supplier to provide SIM cards and information about the use of SIM card-related services. The supplier may be a service supplier, a network operator or another seller. -
Page 11: Getting To Know The Handheld Gps/Gsm Tracker
If you wish to switch on the device, push the button shortly. After a short time, the indicator lights up and a special switch-on signal appears. GH1202 will register to the GSM network and goes immediately into the standby mode. -
Page 12: Indicating The Status
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 INDICATING THE STATUS If you wish to correctly find out the parameters under which the device operates, observe as carefully as possible the status of the three indicators. Each status indicator consists of 2-coloured lamps - one of which is indicating a failure (red) and the other one is indicating a process in progress (green). -
Page 13: Indicating A Button Push
Handheld GPS/GSM Tracker GH1202 INDICATING A BUTTON PUSH If GH1202 is in standby mode you can check if the device is powered with a short button push. The standby check is possible with each button on the keyboard. If the device is powered, the Battery LED will lighten green. -
Page 14: Charging The Battery
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 CHARGING THE BATTERY By connecting the device to one of the USB connectors of a PC or by using the 230V – 5V charger available in the set, it is possible to charge the internal battery of the device. -
Page 15: Installing Software
Before connecting the device to the PC it is recommended to install Track Assistant program at first. When the software installed, GH1202 can be connected to a stationary or portable computer by using an USB data cable. Please wait until the computer detects the new device and it will switch on automatically. -
Page 16: Track Assistant Software
CONFIGURATION OF GH1202 USING A PC Please start the Track Assistant Configuration Tool. After GH1202 has been connected to the PC the battery LED Click the button Connect Tracker if you want to configure your device directly from your PC using an USB cable. - Page 17 Number and the Firmware Version of the device program. Please enter the User Name, which will be shown for this device within the Track Assistant Monitoring Tool, the phone number of the SIM card inserted into the GH1202 and additional Emergency Information about the owner of the device.
- Page 18 (format +441234567890). If this function has been activated, it will protect GH1202 from unwelcome queries via SMS (i.e. Fix?, Inf? Geo? etc.) by external persons without authorization.
- Page 19 You can dedicate a function for each button on the Keyboard. Later on you can activate this function by clicking on the respective button on your GH1202. Please view the section “Indicating a button push” in this manual as well.
- Page 20 User Manual v2.24 Handheld GPS/GSM Tracker GH1202 By ticking next to Vibration, you can activate a vibro. You can also activate a signal warning about incoming or outgoing SMS messages. Choose the ringing tone of the device and set the levels of the ring (Ring Level, 5 = loudest level) and speaker (Speaker Level 10 = loudest level).
- Page 21 User Manual v2.24 Handheld GPS/GSM Tracker GH1202 In the box Alarm Duration Time (sec.) you can specify the duration of the Alarm function. After the specified time passes, the alarm will be automatically turned off. The time is indicated in seconds. If you wish to set the time unlimited you are able to switch of the Alarm with a button push or via SMS.
- Page 22 User Manual v2.24 Handheld GPS/GSM Tracker GH1202 On top you can setup the Event Tracking settings. This track you can activate by pressing a button or sending a special SMS. The Track Update Interval is setting the interval in which the GPS coordinates will be acquired.
- Page 23 Inform about the battery level, when the battery level becomes 50% and 35% or when the level becomes 60% and 40%, as well as when GH1202 is 100% charged Please specify the numbers in the below list of up to 5 numbers, to whom SMS messages notifying about the battery level will be addressed.
-
Page 24: Pin Code
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 If you wish to store the settings into your GH1202 please choose Write to Device. Send Through SMS will be active when a (Teltonika) GSM Modem is connected to your PC. If this option is selected the program will send all configuration changes to the GH1202 device via SMS. - Page 25 Imei:35397601XXXXXXX Time: YYYY.MM.DD HH:MM:SS Version:HH_1.X.X.X CF:1 Live:21511 Op:24602 Cell:030B Sig_Lvl:32 Bat_Lvl:94 GEO? – GH1202 will check in which Geofence zone it is and if it is inside - will send the Geofence zone name. GEO! Id:GH-1202 GEO! Id:GH-1202 Imei:35397601XXXXXXX Time: Imei:35397601XXXXXXX YYYY.MM.DD HH:MM:SS...
- Page 26 MN? – NAVIGON Mobile Navigator 6 ® (Version 6.3 or higher). After receiving such a SMS GH1202 will send back a SMS to the Mobile Phone and you will be able to see the GH1202 position within the NAVIGON software (on the NAVIGON Map).
-
Page 27: Track Assistant Monitoring Tool
SMS queries, which do not need to be memorized because they are already programmed within the program. Stored GPS Data can be reviewed directly from GH1202 (with the USB cable) and can be shown on the map. You can store or export the data. -
Page 28: The Monitoring Tool General View
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 THE MONITORING TOOL GENERAL VIEW The tool consists of five information windows (3, 4, 5, 8, 9) and four software navigation tools (1, 2, 6, 7). System Tools Menu Images Menu Users Profiles... -
Page 29: Image Menu
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 IMAGE MENU Connect Connect GSM Disconnect Disconnect GSM GH1202 Modem GH1202 Modem Open the SMS Erase Positions Open the Edit User Window on the Map Profiles Hide Navigation Show Navigation Read and Store... -
Page 30: List Of Track Logs
Here, you will be able to view the information about the current device status, no matter if it is a Modem or GH1202. If the device connected to the system, you will be able to see the message Device Connected, and if it is a Modem, the message will be GSM Modem Connected, as well as COM PORT to which they are connected. -
Page 31: Transfer Of Logged Data To A Pc
Choose the menu Event Points to transmit the summary of all tracks which has been taken by event (on request by button push or SMS) from the GH1202 to your PC. Choose Periodical Points to show the history of track points based on the periodical GPS Logging (i.e. -
Page 32: Exporting Data To The Google Earth
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 The program window Track Log provides an unique possibility to filter the data read processes based on the date and time. If you wish to see, just the data pertaining to a specific period you need to type the data and time of your choice in the boxes next to the words From and to. -
Page 33: Geozones And Their Detection
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 GEOFENCE ZONES AND THEIR DETECTION This function enables to detect the Geofence zone where the device is located. The user may set up to ten Geofence zones and dedicate names to them. In the settings, you can provide the name of the zone Zone Name, geographical co- ordinates of the centre of the zone Center Longitude, Center Latitude, radius of the zone Radius (in meters) and thickness of the fence of the zone Fence Thickness. -
Page 34: Cross Zone Notification
Now the zone will be deleted and can be created again. 5 – Confirm the selection of the zone (Done) 6 – Save the updates into GH1202 or send the settings via SMS message by clicking the button Write to Device if a GSM Modem is connected. -
Page 35: Maintenance And Repair
User Manual v2.24 Handheld GPS/GSM Tracker GH1202 MAINTENANCE AND REPAIR This device is a high-quality design product; therefore, it should be handled carefully. The following advice will assist you in meeting the guarantee requirements. Do not let the device get wet. In the precipitation, humidity and all sorts of liquids there may be minerals which may be a cause of corrosion of the electricity chains. - Page 36 User Manual v2.24 Handheld GPS/GSM Tracker GH1202 The sign on the packaging means that the User Manual must be read before making use of this product The sign on the packaging means that the electric and electronic equipment to be utilized must be stored separately...
- Page 37 User Manual v2.24 Handheld GPS/GSM Tracker GH1202 Notes...