Connecting An Outdoor Antenna; Connecting Cable Tv - Insignia NS-P42Q-10A User Manual

NS-P42Q-P501Q-P502Q-10A_09-0100_MAN_V1_English.book Page 10 Friday, March 20, 2009 3:11 PM

Connecting an outdoor antenna

Connecting a coaxial antenna
To connect a coaxial antenna:
1 Turn off your TV and all connected equipment.
2 Connect the antenna cable to the ANT IN jack
on the back of your TV.
Connecting a twin-lead antenna
To connect a twin-lead antenna:
1 Turn off your TV and all connected equipment.
2 Place the wires from the twin leads under the
screws on a 300-75 Ω adapter (not included).
Use a screwdriver to tighten the screws.
3 Connect the adapter to the ANT IN jack on the
back of your TV.
ANT IN
Connecting separate VHF and UHF antennas
If you have separate VHF and UHF antennas, you
need to connect the antennas to a combiner (not
included).
To connect separate VHF and UHF antennas:
1 Turn off your TV and all connected equipment.
2 Connect both antenna leads to a combiner (not
included).
10

Connecting cable TV

Without a cable box
ANT IN
With a cable TV box that unscrambles all channels
Connecting a cable TV box that unscrambles some
channels
UHF
VHF
www.insigniaproducts.com
3 Connect the combiner to the ANT IN jack on the
back of your TV.
ANT IN
UHF
V H F
To connect cable TV without a cable box:
1 Turn off your TV and all connected equipment.
2 Connect the cable TV cable to the ANT IN jack
on the back of your TV.
ANT IN
Note
Because your TV is cable-ready, you do not need a
cable box to view unscrambled cable channels.
To connect a cable TV box that unscrambles all
channels:
1 Turn off your TV and all connected equipment.
2 Connect a coaxial cable to the ANT OUT jack on
the cable TV box. This jack may be labeled
ANT OUT, VHF OUT, or OUT.
ANT IN ANT OUT
3 Connect the other end of the cable to the
ANT IN jack on the back of your TV.
ANT IN
4 Connect another coaxial cable between the
ANT OUT jack on the cable TV box and the
cable TV wall jack.
If your cable box unscrambles only some channels
(such as premium channels), you will need a
two-way splitter, an RF (A/B) switch, and four
additional coaxial cables.
To connect a cable TV box that unscrambles
some channels:
1 Turn off your TV and all connected equipment.
2 Disconnect the cable that is connected to the
cable in jack on the cable box. This jack may be
labeled ANT IN, VHF IN, or IN.
Cable in jack