Table of Contents
Advertisement
Malfunction
Water runs out from
under the washing
machine.
Fabric softener is not
added, compartment
À for fabric softener
is filled with water.
Appliance does not
spin, water in the
drum.
Washing is not spun
properly, water is still
visible in the drum.
It is not possible to
open the door.
Remnants of detergent
are building up in the
detergent dispenser
drawer.
Rinse water is cloudy.
Possible Cause
Threaded fitting on the
water inlet hose is leaking.
The inlet hose has a leak.
The drain pump cover is not
tight.
Washing is caught in the
door.
Suction cap in the fabric
softener compartment is not
correctly fitted or is blocked.
o (RINSE HOLD) selected.
Drain hose is kinked.
Drain hose to high.
Drain pump is blocked.
The water drainage system is
blocked.
The door is locked for safety
reasons.
Water tap is not fully open.
The inlet hose filter in the
coupling of the inlet hose at
the tap is blocked.
The inlet valve filter in the
coupling of the inlet hose at
the appliance is blocked.
This is probably due to using
a detergent with a high sili-
cate content.
Operating Instructions
Remedy
Tighten the inlet hose con-
nections.
Check the inlet hose and if
necessary replace it.
Tighten cover by turning
clockwise.
Stop the program, remove
the washing caught in the
door, start a new program.
Clean detergent dispenser
drawer, place suction cap
firmly in position.
Deselect o (RINSE HOLD).
Remove kink.
Check installation
instructions.
Switch off the machine and
pull the plug out of the
socket, clean the drain pump.
Clean the blockage.
Wait 1-2 minutes after the
end of the program.
Open water tap fully.
Clean filter.
Clean filter.
No negative impact on the
rinsing results, try using liq-
uid detergent.
27
Advertisement
Table of Contents
