Page 1
PS07401 7-Inch Polisher / Sander (177.8mm) Assembly & Operating Instructions READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT. This manual provides important information on proper operation & maintenance. Every effort has been made to ensure the accuracy of this manual. These instructions are not meant to cover every possible condition and situation that may occur.
SPECIFICATIONS Rated Current 10 AMP Rated Voltage 120V – 60 Hz No-Load Speed 0 – 3,300 RPM Wheel Diameter 7 Inch (177.8mm) FOR CONSUMER USE ONLY – NOT FOR PROFESSIONAL USE PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions...
NOTE provides additional information that is useful for proper use and maintenance for this tool. If a NOTE is indicated make sure it is fully understood. PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions...
People with pacemakers or other electronic devices should consult with a physician before operating this product. Interruption or failure of the pacemaker could occur when electrical equipment is operated within close proximity of electrical devices. PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions...
Page 6
Do not make contact with a grounded surface while using this power tool. Contact with surfaces like pipes, radiators or major appliances increases your risk of electric shock. PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions...
This manual contains important information regarding safety, operation, maintenance and storage of this product. Before use, read carefully and understand all warnings, cautions, instructions and labels. Failure to do so could result in serious personal injury, property damage or even death. PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions...
Always use the side handle when operating this tool. Using this tool without the handle could result in lose of control, and result in serious injury. Check to be sure the Polisher / Sander is unplugged before installing the Handle. Attach the adjustable handle by screwing it tightly into the tool. PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions...
Secure the loose ends by tucking them under the edge of the bonnet before using the Figure 8 Figure 9 Polisher / Sander (Figure 9) PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions...
Check the Polisher / Sander for disk wear and replace worn or used sanding disks as necessary. When complete, release the Power Trigger and unplug the power cord from the power source. PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions...
If you must use an extension cord, be sure that the gauge is large enough to carry the amount of current necessary for your power tool. If not, your tool may experience a loss of power, excessive voltage drop or overheating. The smaller the gauge number, the heavier the cord. (201005) PS07401 7-Inch Polisher / Sander Assembly & Operating Instructions...