Kenmore 790.9506 Use & Care Manual page 25

Adjusting Oven Temperatures
Your appliance has been factory calibrated and tested to ensure
accurate baking temperatures. For the first few uses, follow your
recipe times and temperature recommendations carefully. If you
think the oven is cooking too hot or too cool for your recipe
times, you may adjust the control so the oven cooks hotter or
cooler than the oven temperature displayed.
The oven temperature may be increased as much as +35°F
(+19°C) or decreased -35°F (-19°C) from the factory calibrated
settings.
To increase (+) or decrease (-) the oven temperature by 20°F:
1. Press and hold Bake until the control produces an audible
tone (about 6 seconds). The factory offset temperature of
0 (zero) should appear in the display.
2. Enter 2 0 using numeric keypad.
3. Press Self Clean to toggle between plus (+) if increasing
temperature or minus (-) if decreasing the temperature.
4. Press to accept change.
Important note:
• Oven temperature adjustments will not change the Broil or
Self Clean function temperatures.
• If the temperature shows an adjustment of -20°F, and a
+20°F adjustment is needed, toggle between the minus (-)
or plus (+) in the display by pressing the Self Clean key.
• Do not use oven thermometers such as those found in
grocery stores to check the temperature settings inside your
oven. These oven thermometers may vary as much as 20 to
40°F degrees from actual temperatures.
• The oven temperature adjustment may be made if your
oven control is set to display temperatures in °C (Celsius).
Minimum and maximum settings for Celsius range from plus
(+)19°C to minus (-) 19°C.
Using AirGuard™ feature
Your appliance is equipped with a catalytic oven exhaust
cleaner that may be turned on during any active oven cooking
process. This feature helps remove smoke and eliminates 85% of
the odors generated when using your oven.
If you wish to have this AirGuard clean the oven exhaust once
cooking has started, press
To turn AirGuard off press
Important note:
The AirGuard indicator light will display when the AirGuard is
active (Figure 36). AirGuard will turn on automatically and
cannot be manually turned off when Self Clean is active.
Figure 36: Active Air Guard
25
Setting Oven Controls
.
.