Portable Diversity Tuner (Urx-P2); Power Switch - Sony UWP-V1 Operating Instructions Manual

A AF (audio frequency) indication
Appears whenever the input audio signal is
stronger than the reference level.
B RF (radio frequency) indication
Appears during signal transmission from
the antenna.
C BATT (battery) indication
Shows the battery condition.
For details, see "Battery indication" on page 43.
D CH (channel) indication
Shows the transmission channel. Each time
you press the SET button in transmission
mode, the channel indication changes as
follows.
For details, see "Transmitter Settings" on page 54.
Transmission
channel
Transmission
frequency
Attenuation
level of the
input signal
Accumulated
use time
The channel/frequency indications for
U30 model are shown.
e + (+ selection) / – (– selection/reset)
buttons
Press these buttons to set the transmission
channel, frequency, or attenuation level of
the input signal.
The "–" button resets the accumulated use
time to "00:00".
f SET button
Press to change and enter display
parameters.
For details, see "Transmitter Settings" on page 54.
g POWER switch
Turns the power of the microphone ON or
OFF.
h Battery compartment
Accommodates two LR6 (size AA) alkaline
batteries.
For details on how to insert the batteries, see
"Power Supply" on page 42.
Portable diversity tuner
(URX-P2)
Press
the
SET
button.
a Antennas
b MONITOR connector (3.5-mm
diameter stereo mini jack)
To monitor the tuner output, connect the
headphones to this connector.
Parts Identification 39