Advertisement
Quick Links
Advertisement
Related Manuals for King Canada Power Force KCG-2PG
Summary of Contents for King Canada Power Force KCG-2PG
- Page 1 2” GASOLINE WATER PUMP Read this manual. Do not attempt to operate this water pump until you have read and understood the safety, operation, and maintenance instructions MODEL: KCG-2PG INSTRUCTION MANUAL COPYRIGHT © 2006 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Warranty And Service Information
KING CANADA shall in no event be liable for death, injuries to persons or property or for incidental, special or consequential damages arising from the use of our products. Shipping and handling charges may apply. If a defect is found, KING CANADA will either repair or replace the product. - Page 3 BASIC & SPECIFIC WARNINGS BASIC SAFETY WARNINGS INADEQUATE VENTILATION FOR WATER PUMP BE CAREFUL! Materials placed against or near the water pump or operating the water pump in areas where the temperature exceeds 40° C ambient DO NOT USE IN YOUR HOUSE (such as storage rooms or garages) can interfere with its proper KEEP FLAMMABLE MATERIALS AWAY ventilation features causing overheating and possible ignition of the...
-
Page 4: Getting To Know Your Water Pump
GETTING TO KNOW YOUR WATER PUMP 1. Power ON switch. This switch must be switched to “ON” before fuel filter inside the fuel filter cap. pulling recoil starter. 12. Fuel Shut-off Valve Lever. Regulates the flow of fuel to the 2. - Page 5 INSPECTION & SET-UP BEFORE STARTING ENGINE WARNING! To prevent permanent damage to your water pump, you MUST check oil level, fuel level, air cleaner filter, assemble all hoses (not supplied), hose adaptors and strainer basket, prime the water pump and have the inlet hose submerged in water before starting water pump engine.
- Page 6 INSPECTION & SET-UP BEFORE STARTING ENGINE WARNING! To prevent permanent damage to your water pump, you MUST assemble all hoses (not supplied), hose adaptors and strainer basket if needed, prime the water pump and have the inlet hose submerged in water before starting water pump engine. CONNECTING HOSE ADAPTORS TO PUMP INLET AND OUTLET;...
- Page 7 STARTING/STOPPING YOUR WATER PUMP BEFORE STARTING THIS WATER PUMP, MAKE SURE THE INSPECTION AND SET-UP INSTRUCTIONS ON THE 2 PREVIOUS PAGES HAVE BEEN FOLLOWED OR ELSE YOU RISK DAMAGING YOUR WATER PUMP AND VOIDING WARRANTY. STARTING YOUR WATER PUMP Warning! Never run engine indoors or in enclosed, poor ventilated areas, engine exhaust contains carbon monoxide, an odorless and deadly gas! NOTE: IF ENGINE OIL LEVEL IS TOO LOW, ENGINE WILL NOT START.
-
Page 8: Maintenance And Storage
MAINTENANCE & STORAGE Engine Oil Replacement (Oil capacity: 0.6 Liters) Engine oil should be replaced after the first 20 hours of operation or after the first month of use, it should be replaced every 100 hours or 6 months after. To replace engine oil; 1) Unscrew and remove the oil gauge dipstick (A) Fig.12. - Page 9 INSPECTION & TROUBLESHOOTING Daily and Regular Inspection Every Every 20 Every 50 Every 100 Item Time Operation hours hours hours WARNING! Daily and regular inspection is important to Inspection and tightening of ensure safe, proper and long-term operation of the bolt and nut at each place engine.
-
Page 10: Troubleshooting
5. Open fuel shut-off valve. 6. Spark plug wire loose. 6. Attach wire to spark plug. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.