Table of Contents
Advertisement
If no signals are received, blank "—-" will be displayed. Press and
hold [SEARCH] for 2 seconds to activate search for the remote
thermo signal from the sensor.
If that fails, check if the remote thermo sensor is still in place. Try
repositioning the units as they may be having temperature trans-
mission block as a result of interference.
Note: Failure of reception of remote signals may be due to the fol-
lowing reasons:
1. Battery power of the units is too low.
Suggested Solution: Replace with fresh batteries if necessary.
2. Batteries may freeze when the temperature falls below the
freezing point. Frozen batteries will have a lower voltage and
therefore result in a shorter transmission range.
Suggested Solution: Shorten the transmission range by
repositioning the units.
3. Transmission path is blocked with obstacles and interference
from the surroundings.
Suggested Solution: Shorten the distance (e.g., move the main
unit closer to the window) or relocate the units when necessary.
MAXIMUM AND MINIMUM
TEMPERATURE
The maximum and minimum indoor-remote temperatures recorded
will be automatically stored in memory. Press [MEM] to toggle
among the current, maximum and minimum indoor and remote tem-
perature records. The respective "MAX" or "MIN" indicator will
be shown.
To clear the memory, press and hold [MEM] for 2 seconds when
the maximum or minimum record is being displayed. The memory
will be erased and replaced with current temperature until a new
maximum or minimum reading has been recorded.
If the temperature readings recorded are lower or higher the
measuring range, "LLL" or "HHH" will be displayed respectively.
PRESSURE TREND
This unit gives a barometric pressure trend for the last hour.
Arrow
Indicator
Pressure
Trend
Rising
WEATHER FORECAST
BARM123A detects barometric pressure changes and displays
weather symbols including sunny, partly cloudy, cloudy, rainy and
snow that indicate weather forecasts for the next 12 to 24 hours.
The radius of the forecast is approximately 30 – 50 km or 18-30
miles.
Steady
Falling
7
sunny
partly cloudy
rainy
Section IV — Soothing Sounds
This unit is also featured with a Soothing Sounds function which
can give out relaxing sounds continuously to mask the noise in the
surroundings. There are 6 nature-simulating sounds which you can
choose from: (1) Bird sounds, (2) Wind sounds, (3) River sounds,
(4) Rain Drop sounds (5) Waterfall sounds and (6) Ocean Wave
sounds.
To turn on the Soothing Sounds, press [POWER ]. Press
[RADIO/SOUND] to select Soothing Sounds function. Press
[SELECT] to toggle among the 6 different sounds. The respective
LED will also light up to indicate the selected sound.
To adjust the volume, use [VOLUME
increase or decrease the volume.
To turn off the Soothing Sounds, press [POWER ] to do so or
[RADIO/SOUND] to switch to Radio function.
Section VI — Others
BACKLIGHT
To turn on the EL backlight of the LCD Display, press [SNOOZE/
LIGHT] to turn it on for 5 seconds.
HOW TO RESET THE UNIT
Press [RESET] only in the following circumstances:
1. To enhance synchronization of signals after battery replacement
2. To reset the settings when the unit is malfunctioning
When [RESET] is pressed, all settings will return to the default
values and memory records will be erased.
PRECAUTIONS
This unit is engineered to give you years of satisfactory service if
handled with care.
1. Do not immerse the unit into water.
2. Do note clean the unit with abrasive or corrosive materials.
3. Do not subject the unit to snow or excessive force, shock, dust,
temperature or humidity.
4. Do not tamper with the unit's interal components.
5. Do not mix new and old batteries or batteries of different
specifications.
cloudy
snow
] or [VOLUME
] to
Advertisement
Table of Contents
