Care And Maintenance - Peavey Messenger Series Pro Sub P Operating Instructions Manual

DISTORTED OR FUZZY SOUND
Ensure the mixer (signal source) is not clipping or being overdriven. Check that the level control (8) on the PRO™
Sub P has not been set too low.
The input plugs should be fully seated in the input jacks (6) and (7) on the rear panel of the PRO™ Sub P. Ensure
that the power amp has not been plugged into one of the input jacks of the PRO™ Sub P.
If excessive additional bass boost has been added externally to the PRO™ Sub P, it could cause premature
overload at high SPL. Reduce the amount of any external (mixer, rack) EQ and see if that eliminates the distortion.
Finally, be aware that even though the PRO™ Sub P is a powerful and high output unit, it does ultimately have
limits and it may need additional powered units to provide enough sound output or coverage. Try turning the mixer
levels down.
If, after checking all the things listed above, the problem still persists contact your Peavey dealer for advice.

CARE AND MAINTENANCE

Your PRO™ Sub P is a sturdy and durable product and will provide years of reliable use if properly cared for.
Use common sense and read the safety warnings to avoid hazardous operating conditions. The unit must be
disconnected from the AC power source before any work is done on it. Refer all servicing to qualified service
personnel.
Sunlight/Heat
Avoid prolonged exposure to direct sunlight as this may cause the unit to overheat and thermally shut
off. Excessively hot operating conditions can also cause a thermal shut-down.
Do not store in extremely hot or cold conditions or extremely high humidity. Always allow unit to come to
room temperature before use.
Cleaning
Never clean the PRO™ Sub P while plugged in or turned ON! Do not allow ANY fluids to drip inside the
PRO™ Sub P.