1. Manuals
  2. Brands
  3. QCA Spa Manuals
  4. Hot Tub
  5. VS501 PAK (VL260 TOPSIDE)
  6. Owner's manual

QCA Spa VS501 PAK (VL260 TOPSIDE) Owner's Manual

Qca spa
Hide thumbs
Table of Contents

Advertisement

Quick Links

ENJOY
Your QCA Spa
VS501 PAK (VL260 TOPSIDE)
OWNER'S MANUAL
This owner's manual is for YOU! It will show you how to operate and maintain your very own spa.
We think it is important for you to take a few moments and get acquainted with your new spa
operation. Please keep this manual available for references.
QCA Spas would like to congratulate you on your purchase and we sincerely hope you enjoy your
QCA Spa.

SERIAL NUMBER _____________

18 DIGIT SPA NUMBER ____________
QCA Spa VS501-VL260 10.08
Technical Service Toll Free 866-998-0148

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VS501 PAK (VL260 TOPSIDE) and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for QCA Spa VS501 PAK (VL260 TOPSIDE)

Summary of Contents for QCA Spa VS501 PAK (VL260 TOPSIDE)

  • Page 1: Serial Number

    We think it is important for you to take a few moments and get acquainted with your new spa operation. Please keep this manual available for references. QCA Spas would like to congratulate you on your purchase and we sincerely hope you enjoy your QCA Spa.

  • Page 2: Table Of Contents

    TABLE OF CONTENTS Cleaning the Filter Cartridge ................8 Diagnostic Messages ..................6 Draining the Water ..................7 Filter Maintenance....................8 Hyperthermia Description.................3 Initial Start Up ....................5 Installation Instructions ..................4 115/230v Installations ..................4 Prevention of Freezing ..................9 Refilling your Spa....................7 Removing the Box Filter Cartridge ..............8 Spa and Cabinet Maintenance ................9 Spa Location......................4 Spa Top Side Control ..................5...

  • Page 3: Ul Instructions

    These instructions are very important for your safety and to 100°F (38°C). QCA would like to encourage you to read and apply all instructions. Thank you. c. Before entering a spa or hot tub, the user should...

  • Page 4: Installation Instructions

    CUSTOMER WARNING: The National Electric code requires a Ground Fault Circuit Interrupter on all spas, the #160A kit GFCI is available through your QCA Spa Dealer. Alert your electrician that if another GFCI is used it must have Neutral Protection.

  • Page 5: Initial Start Up

    YOUR • QCA • SPA • EQUIPMENT VL260 Series Control VS501 =Jets2 / Jets1 / Temp / Light Initial Start Up When your spa is first actuated, it will go into Priming mode, indicated by “Pr.” The Priming mode will last for less than 5 minutes (press "Temp"...

  • Page 6: Diagnostic Messages

    Diagnostic Messages Message Meaning Action Required No message on display. The control panel will be disabled until power returns. Spa Power has been cut off to the Spa. settings will be preserved until next power up. Temperature unknown. After the pump has been running for 2 minutes, the temperature will be displayed.

  • Page 7: Refilling Your Spa

    Before adding chemicals to your spa, do a full water or remove lenses simply push ON or pull OFF of the spa analysis with a test kit or ask your QCA Spa dealer to light, as shown below. conduct the water test for you. (The following is an illustration of the steps taken when Bromine is the water care program.

  • Page 8: Cleaning The Filter Cartridge

    In your QCA Spa, it tie-downs. is important to maintain a clean, unobstructed filtering system. This not only provides the maximum performance...

  • Page 9: Prevention Of Freezing

    Please Note: The following corrective actions may be performed by the spa owner. If the trouble cannot be corrected in the steps below, please refer to your QCA Spas, Inc. Dealer for service. (Improper servicing by an unauthorized serviceman or spa owner could result in damage that will not be covered by the warranty, or could cause serious injury.)Diagnostic...
  • Page 10 January 1, 2008. To validate this warranty, the Purchaser must complete the enclosed warranty registration card and mail it to QCA Spas within 30 days of deliver of the spa. RETURN OF THE OWNER REGISTRATION CARD IS A CONDITION OF WARRANTY COVERAGE. This warranty is exclusive and supersedes all other representations or obligations of QCA Spas, whether express or implied and whether oral, written or printed.

Table of Contents