Related Manuals for Edge Craft Chef'sChoice 110
Summary of Contents for Edge Craft Chef'sChoice 110
- Page 1 InstructIOns MODEL 110 ® Diamond Hone Sharpener Read these instructions before use. It is essential that you follow these instructions to achieve optimum results. © 2014 EdgeCraft Corp.
-
Page 2: Important Safeguards
Important SafeguardS When using electrical appliances, basic safety precautions should always be followed including the following: 1. Read all instructions. ® 2. To protect against electrical hazards, do not immerse the Chef’sChoice in water or other liquid. ® 3. Make sure only clean knife blades are inserted in the Chef’sChoice 4. - Page 3 You made a good ChoICe ® Congratulations on your selection of the Chef’sChoice Diamond ® Hone Sharpener Professional 110. With the Professional 110 you can ® produce the incredibly sharp triple bevel Trizor edges on your favorite kitchen, sporting or pocket knife. ®...
-
Page 4: Sharpening Knife For The First Time
gettIng to KnoW Your Sharpener Before using your sharpener you may wish to become familiar with its features. Do not plug the sharpener cord into the an outlet. (Refer to Figures 1 and 2). 1. Place the heel area of a knife blade in one of the sharpening slots of Stage 2 or 3 (Figure 3). - Page 5 left side of the slot. Pull the knife towards you allowing the magnet to position the blade at the proper sharpening angle. Keep a secure yet relatively loose grip. Your grip should be just loose enough that the magnets totally control the blade angle. DO NOT apply downward pressure on the knife blade.
-
Page 6: Resharpening
Stage 2— Four (4) to eight (8) slow passes through each slot (left and right SHARPENING slot). Alternate each pass. Stage 3— Eight (8) fast passes through each slot (left and right HONING slot). Alternate each pass. slot. Again, take about three (3) seconds per pass for a 6” blade. As before, alternate each pull from left to right SHARPENING slots. - Page 7 1. Loosen Your Grip on the Knife. Let the magnets take total control of the knife position and sharpening angle. Allow the lower portion of the knife face to be pulled by the magnets flat against the guide plane of the magnets. Do not resist the pull of the magnets. The magnets will also automatically pull the knife down against the moving diamonds and apply the correct sharpening pressure.
-
Page 8: Chef’s Knives And Paring Knives
Chef’S KnIVeS and parIng KnIVeS The blade of a well designed chef’s knife is curved continuously from the blade tip to the end near the handle so that, with a rocking action on a cutting surface, the entire blade length will ®...
Need help?
Do you have a question about the Chef'sChoice 110 and is the answer not in the manual?
Questions and answers
Can I sharpen scissors with this
I inherited a model 110 diamond hone sharpener. The "pre-sharpening:" slots work fine, but neither the secondary or final hone slots contact the blade. I've read the instructions over numerous times for ideas, but now I suspect something is definitely wrong. I'm damn handy with tools, but I can't identify what's wrong here. The motor, the magnets, etc. all work as they should, but again, no blade contact with the secondary and hone slots. I'm stumped. Appreciate your advice and comments. Can you refurbish older sharpeners? I really like this thing. Thanks in advance for your attention to my questions. Regards, Terry Bailey