Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for ScienceTech Bigshot
-
Page 1: Instruction Manual
Instruction Manual Build . Learn . Use www.bigshotcamera.com Ages 8 - 108 years... -
Page 2: Table Of Contents
Contents Safety Build A Getting Started B Power Generator Electronics D Lens Wheel E LED Flash P.10 Camera Parts P.11 Charging the Battery P.12 Bigshot Software P.13... -
Page 3: Safety
Safety Always ensure that the camera is operated according to the instructions below, which are intended to prevent injuries to yourself and other persons, or prevent damage to the camera. WARNING: Possibility of serious injury 1. Do not trigger the flash in close proximity to people's eyes. Exposure to the intense light produced by the flash could damage eyesight. -
Page 5: B Power Generator
Build B Power Generator Slide gear A into the hole on the side While holding the gear in place with of the camera body. The blue arrow one finger, insert one of the axle rods tells you the direction in which to into the middle hole of the gear. - Page 6 Build B Power Generator Push the axel rod from the left all Place the dynamo into the camera the way so that it enters the hole body. Make sure the dynamo gear in the camera body on the right. meshes correctly with gear B. Don't try to rotate any of the gears as it may cause the axle rods to pop out of their positions.
-
Page 7: C Electronics
Build B Power Generator B12. Rotate the hand crank clockwise. If B13. Clip the white crank cap onto the it does not rotate smoothly, one of hand crank so that it covers the three the parts of the gearbox may be screws. - Page 8 Build C Electronics Pick up the PCB module and turn Insert the PCB module into the camera the mode knob to the position body. Make sure the pillars in the shown above. camera body go through the holes in the PCB module. Fasten the PCB module onto the Now set the mode knob to the OFF camera body using three screws.
- Page 9 Build C Electronics If you want to disconnect the wires, Take the remaining connector from then press down on the smaller the PCB module and the connector connector and pull it out as shown from the battery. Gently connect the above.
-
Page 11: D Lens Wheel
Build D Lens Wheel Now cover the second spring with Push-fit the lens wheel into the the second spring cover. casing of the PCB module. Make sure the two locks on the lens wheel align correctly with the two notches on the PCB module, as illustrated by the blue and purple boxes. -
Page 12: E Led Flash
Build E LED Flash Take the LED flash module and Turn the LED flash module clockwise insert it into the PCB module. The to lock it into the PCB module. flash module can be inserted in only one orientation. Make sure that you match and align the tabs on the flash module with the notches on the PCB module (see blue and... -
Page 13: Use
Camera Parts Front of the Camera Shoot button Hand crank Mode dial Timer LED Lens wheel LED flash Regular lens Wide Angle lens Stereo/3D prism 10. USB Connector Back of the Camera Mode dial Viewfinder Display USB connector Shoot button Power indicator Top button Middle button... -
Page 14: B Charging The Battery
Charging the Battery Before you start using the camera, you will have to charge the battery. There are two ways to charge the battery: using a USB charger or using the hand crank. We suggest you use the first method whenever possible, and reserve the second method for when you do not have access to a computer. -
Page 15: C Bigshot Software
Bigshot Software Please download Bigshot software from: www.bigshotcamera.com... - Page 16 Build . Learn . Use www.bigshotcamera.com ScienceTech is a registered trademark of Edu-Science (H.K.) Ltd. Bigshot is a registered trademark of Kimera LLC, NY. Copyright © 2013 Kimera LLC. All rights reserved. P38-EL362-81001000...