Sylvania Srcvt120-150 Instruction Manual

PLUg in convector heater with ProgrammabLe thermostat
Model: Srcvt120-150
imPortant
PLease note when yoU oPen the carton carefULLy check
the Unit and make sUre there is no damage. if yoU have any
ProbLems with the Unit, with how the varioUs fUnctions
work, damaged or missing Parts PLease caLL 1-800-459-4409
(8:30 am to 5 Pm est) immediateLy for service.
note: do not retUrn Unit to the store before caLLing the toLL
free nUmber. do not disPose of yoUr cartons UntiL yoU are
comPLeteLy satisfied with yoUr new convector heater.
INSTRUCTION MANUAL
attention:
1. Find a location for the convection heater that is protected from direct sunlight.
2. Do not plug the unit into the power outlet before reading all instructions.
IMPORTANT SAFETY INSTRUCTIONS
when Using eLectricaL aPPLiances, basic PrecaUtions shoULd
aLways be foLLowed to redUce the risk of fire, eLectric shock,
and inJUry to Persons, incLUding the foLLowing:
1) read all instructions carefully before using the heater.
2) this heater is hot when in use. to avoid burns, do not let bare skin
touch hot surfaces. if provided, use handles when moving this heater.
keep combustible materials such as furniture, pillows, bedding,
papers, clothing and curtains at least 3 feet (0.9 m) away from front,
sides and rear of the heater.
3) extreme caution is necessary when any heater is used by or near
children or individuals with disabilities and whenever the heater is
left operating and unattended.
4) do not operate the heater with a damaged cord or plug or if the
heater malfunctions, has been dropped or damaged in any manner.
disconnect power at service panel and have heater inspected by a
qualified electrician before use.
5) do not use outdoors.
6) this heater is not intended for use in bathrooms, laundry areas or in
wet or moist indoor locations. never place the heater where it may
fall into a bathtub or other water containers.
7) to disconnect the heater, turn controls to off then remove plug from
outlet.
8) do not insert or allow foreign objects to enter any ventilation or
exhaust openings as this may cause an electric shock, fire or may
damage the heater. do not use on soft surfaces, such as a bed where
openings may become blocked.
9) to prevent possible fire, do not block air intakes or exhaust in any
manner.
10) heaters may have hot and sparking parts inside. do not use it
in areas where gasoline, paint or flammable liquids are used or
stored.
11) Use this heater only as described in this manual. any other use not
recommended by the manufacturer may cause fire, electric shock
or injury to persons.
12) do not run the electric cord under carpeting. do not cover the cord
with throw rugs, runners or similar coverings. do not place the
cord in a traffic area.
13) always plug heater directly into a wall electrical outlet. never use
with an extension cord or power bar.
14) always unplug heater when not in use.
15) connect to properly grounded outlets only.
16) avoid the use of extension cord as the cord may overheat and cause
a risk of fire. however, if you must use an extension cord, the plug
must be a grounding type, 3-wire cord, no. 14 awg minimum size
and rated not less than 1875 watts.
SAVE THESE INSTRUCTIONS FOR FUTURE USE.
warning:
Procedures and techniques if not carefully followed will result in dam-
age to the equipment and will expose the user to the risk of serious
injury, illness or death.
this heater is for use on 120 volts. the cord has a plug as shown at a in
illustration below. an adapter as shown at c is available for connecting
three-blade grounding-type plugs to two-slot receptacles. the green
grounding plug extending from the adapter must be connected to a
permanent ground such as a properly grounded outlet box. the adapter
should not be used if a three-slot grounded receptacle is available.

GENERAL INFORMATION

this convection heater is intended for permanent wall-mounting with the
provided brackets.
the heater has a thermal cut-off protection. If the thermal cut-off protection trips,
switch off the power. the unit should reset automatically after 10 minutes. If the
thermal cut-off protection trips again, determine the reason for overheating.

SPECIFICATIONS

modeL voLts watts height width dePth
Srcvt 120-150 120vAc
1
1500W 443 MM 581 MM 112 MM