Installation and Operation Manual
Watering Start Times
Watering Start Times allows you to select when each program begins to water. Each
program can have up to 6 start times. Setup is the same for both timer programs (A, B,
C, and D) and sensor programs (S1, S2, S3...S36).
1. Press the + or - Adjust Value buttons to select
which program start times you want to setup.
2. Press the
Next and
move between each of the 6 start times.
3. Use the + or - Adjust Value button to select
the desired start time.
Soil Moisture Sensors
Soil Moisture Sensors enable you to adjust the moisture thresholds for each sensor in the
system and take a sensor reading. Sensors read and display:
· Soil Moisture – reported as percent moisture by volume
· Soil Temperature in degrees Fahrenheit
· Soil Conductivity reported in deci-Siemems per meter (dS/m).
The default soil moisture threshold is 25%. You should adjust your thresholds based on
your unique soil conditions in accordance with instructions at page 13-14.
After a few seconds the sensor reports the current soil moisture, temperature, and
electrical conductivity at the sensor.
Page 13
Prev buttons to
1. Press + or – Adjust Value to select the
sensor.
2. Press Next to move to the threshold field and
use the + or - Adjust Value buttons to change
the threshold.
3. To read the sensor press Next to move to the
Read Sensor field and press the + Adjust Value
button to take a sensor reading.