Advertisement
Installation
Important
The grill drawer is not intended to be installed under a worktop and is
intended to be installed underneath a CDA compact appliance.
Do not install this product in locations where the top of the grill
drawer is within 25mm of a wooden supporting shelf.
Failure to allow adequate ventilation to the appliance may result in
overheating or damage to adjacent units and could invalidate the
warranty.
This appliance is type X installation.
The walls of the kitchen units must be able to withstand temperatures
of 75˚C above ambient (typically this is between 90˚C and 100˚C).
When correctly installed ensure that there is a gap of 4mm minimum
between the sides of the grill drawer and adjacent furniture doors.
Lift the grill drawer carefully into position on the shelf, taking care
NOT to lift it by the door handle. When the drawer is open, there are
two screw holes visible, one on each side of the housing. The grill
drawer should then be secured to the housing by fitting screws into
these holes. Remember the housing should not be free standing but
be secured to the wall and/or adjacent fittings.
11
Advertisement
