Advertisement
RePlAcINg BATTeRIeS
1. Open the battery compartment on the front of the of the sensor.
2. Remove any old batteries.
3. Place four fresh alkaline LR44 batteries into the sensor. The correct orientation is
shown on the base of the battery compartment. Use only alkaline batteries. Do not use
rechargeable batteries.
To test the current state of your batteries, press the TEST button, located in the battery
compartment. If the Battery Indicator LED will lights up then the batteries have enough
power to operate the alarm. If it does not light up or is dim, then you should replace the
batteries as soon as possible.
TecHNIcAl SPecIFIcATIONS
Power Requirements
Siren Duration
Siren Volume
Magnetic Switch Trigger
WARNING—Risk of Personal Injury Prolonged exposure to alarm siren may cause permanent hearing damage or loss.
FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference. (2) This device must accept any interference received including interference that may cause undesired operation.
* Federal Communications Commission (FCC) Statement
WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures: — Reorient or relocate the receiving antenna. — Increase the separation between
the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced
radio/TV technician for help.
* You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
(4) x LR44 Button Cell Batteries (6V DC)
60 seconds (approx.)
110db
10mm—26mm
Advertisement
