Hamilton Beach HB-363 Owner's Manual page 11

1. separate the pre-motor filter from the mesh cassette. each filter can be tapped
against the side of a trash can to remove the excess dirt and dust.
Note: This filter should be checked and cleaned periodically.
2. Return the pre-motor filter and cassette to the vacuum cleaner. Replace the pre-motor
filter cover before restarting the vacuum cleaner.
d. Cleaning the Cover outlet filter
Note: This is located between the rear faux wheels of the vacuum.
1. Release the cover outlet filter and remove the cover as shown. Remove the filter by
pulling the tab towards you (fig. 6/6).
2. The filter can be tapped against the side of a trash can to remove the excess dirt
and dust.
3. Return the cover outlet filter to the vacuum cleaner. Replace the cover before
restarting the vacuum cleaner.
IMPORTANT: The motor of this product has a thermal cut-off to protect the unit from
overheating. The safety switch will turn off the unit when the motor overheats, which is
usually the result of abnormal use of the unit. The product will resume to normal working
conditions once the motor is completely cooled down.
IMPORTANT: Cleaning the filters regularly improves the vacuuming performance. Make
sure that all the filters are replaced back into the vacuum cleaner before using. This
vacuum cleaner is intended for household use only and not for commercial or industrial
use. Store the vacuum in a cool dry area. Any other service should be performed by an
authorized service center.
fig 6/6
9