Toshiba RAS-13SKV-E Service Manual page 97

No. Part name

Front panel 4) Press "PUSH" part under the front panel
5) Remove the front panel fixing screws.
6) Take off three hooks of panel from rear
<How to assemble the front panel>
1) Press three center positions and two lower center positions of the air outlet, and
2) Insert the plasma air purifier (for model RAS-10,13,16SKVR-E).
3) Tighten two screws.
Procedures
and remove hooks of the front panel from
the installation plate.
(2 pcs.)
side.
then hang the hanging hooks (3 pcs.) at the top side of the front panel to the rear
plate.
Press in the plasma air parifier until the protrusions on both sides are completely
inserted into the holders.
If installation is incomplete, the FILTER indicator (orange) may light.
Plasma air purifier
Holder
• Incomplete hanging or incomplete pressing may cause a dewdrops or generation
of a fluttering sound.
Protrusion
Protrusion
Plasma air purifier
– 97 –
Remarks
Installation plate
Front panel
Press
2 Screws
Three hooks
Holder