Summary of Contents for SignVideo ENG-44
- Page 1 ENG-44 Field Portable Audio Mixer Operator’s Manual SignVideo - 1226 SE Gideon Street - Portland, Oregon 97202 signvideo .com 503.236.0000...
-
Page 2: One-Year Limited Warranty
Should the product be found to be defective, Sign Video Ltd. will repair or replace the product at no charge. To obtain warranty service telephone one of the numbers below or log on www.signvideo.com to obtain the current telephone number for warranty repair. - Page 3 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
-
Page 4: Front Panel
ENG-44 Front Panel CH1-CH4 Gain Controls Individual gain controls for each of the four input audio channels, marked 1-4. Gain controls are also known as faders or level controls. Master Gain Control Controls overall gain. FLAT/Low Cut Filter Switches Switches for each of the four input channels select between flat (no filter) and 100 Hz roll off (attenuates audio in frequencies below 100 Hz). -
Page 5: Left Panel
ENG-44 Left Panel MIC/LINE XLR Inputs Channel 1 through 4 XLR transformer balanced audio inputs. Use individual selector switches located on the underside panel of the unit to choose mic/line level for each input and to activate/ deactivate +48 volt phantom power for each input. -
Page 6: Right Panel
ENG-44 Right Panel Boom Head Phone Out XLR audio output for boom operator head phone monitoring. XLR output allows use of cable with XLR connectors rather than one with ¼” connectors. Use a ¼” adapter to connect to head phones. This way your spare XLR cable also serves as your spare boom operator cable, and you only need carry a small spare ¼”... -
Page 7: Rear Panel
ENG-44 Rear Panel 1. External Power 2.1mm ID x 5.5mm OD external power jack. While this unit can operate fully on battery power, this input allows the unit to also be powered from a wall power outlet by using a power adapter. Plug the AC power adapter itself into the wall outlet, then connect the AC adapter’s low voltage DC output cord to this... - Page 8 ENG-44 Underside Panel 1. Mic/Line Switches Individual switches for each input channel select between mic and line level in. One switch for both xlr outputs switches between mic and line level out. 2. Phantom Power Switches Individual switches for each input channel activate/deactivate +48 Volt phantom power.
- Page 9 To avoid this problem, you can purchase a SignVideo XLR-Pro™ Audio Adapter and connect it to your camcorder. Then you can feed a balanced audio signal from the XLR outputs of the mixer to the XLR inputs of the XLR-Pro™...
Need help?
Do you have a question about the ENG-44 and is the answer not in the manual?
Questions and answers