Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for AUDAC APT20
- Page 1 APT20 User Manual www.audac.eu...
-
Page 3: Table Of Contents
Caution servicing EC Declaration of conformity Waste of Electrical and Electronic Equipment (WEEE) Caution Chapter 1: Pin connections & connectors Chapter 2: Overview APT20 Front panel Rear panel Chapter 3: APT20 Quick start guide Chapter 4: Additional information Technical specifications... -
Page 5: Introduction
Introduction Two channel phantom power supply The APT20 is phantom power supply unit containing two independant working channels for use with two condenser microphones. It supplies 48V DC to the microphones and routes the signal to a mixer or microphone amplifier. -
Page 6: Precautions
Precautions READ FOLLOWING INSTRUCTIONS FOR YOUR OWN SAFETY ALWAYS KEEP THESE INSTRUCTIONS. NEVER THROW THEM AWAY ALWAYS HANDLE THIS UNIT WITH CARE HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS NEVER EXPOSE THIS EQUIPMENT TO RAIN, MOISTURE, ANY DRIPPING OR SPLASHING LIQUID. AND NEVER PLACE AN OBJECT FILLED WITH LIQUID ON TOP OF THIS DEVICE. -
Page 7: Ec Declaration Of Conformity
EC DECLARATION OF CONFORMITY This product conforms to all the essential requirements and further relevant specifications described in following directives: 2004/108/EC (EMC) and 2006/95/EC (LVD) WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE) The WEEE marking indicates that this product should not be disposed with regular houshold waste at the end of its working life. -
Page 8: Chapter 1: Pin Connections & Connectors
Chapter 1 Pin connections and connectors CONNECTION STANDARDS The in- and output connections for AUDAC audio equipment are performed corresponding to international wiring standards for professional audio equipment. XLR: For balanced microphone input connections Pin 1: Ground Pin 2: Signal +... -
Page 9: Chapter 2: Overview Apt20
Chapter 2 Overview APT20 Front panel The front panel of the APT20 contains all connections for connecting two condenser microphones and routing their signal to a mixer or microphone amplifier 1) XLR input connectors: The condenser microphones should be connected to the input XLR connectors. The... -
Page 10: Rear Panel
Rear panel Power The rear panel of the APT20 contains the power switch, mains power inlet and power indication LED. 1) Power switch: By toggling this switch, the power for the APT20 can be switched ON and OFF. The power LED will illuminate when the power is switched ON. -
Page 11: Chapter 3: Apt20 Quick Start Guide
Chapter 3 APT20 Quick start guide This chapter guides you through the setup process of a basic project with one APT20 phantom power supply, two condenser microphones and a mixer or microphone amplifier. Overview of the APT20 setup 1) Connecting the APT20... -
Page 12: Chapter 4: Additional Information
Chapter 4 Additional information Technical specifications Peripheral Inputs 2 x Microphone input Outputs 2 x Microphone output Connectors Microphone input 3-Pin Female XLR Microphone output 3-Pin Male XLR Power IEC Mains connector with fuse (Fuse type: T0.5A/250V) Specifications Phantom power 48 Volt THD+N <...
Need help?
Do you have a question about the APT20 and is the answer not in the manual?
Questions and answers