Section 3. Installation; Section 3.2 Operating Location - Henry Radio 3K Classic Mark II Operating And Maintenance Manual

SECTION 3. INSTALLATION
SECTION 3.1 UNPACKING
When
you first receive the ahplifitr you must carefully inspect first tQ.
box and then the amplifier for any sign of damage during shipment.
If you
see any shipping damage,
save the box and packing material and notify ?.h:^
transportation company immediately.
It is a good idea to save the box and
packing material in any case nr.::aur-.r they are expensive to replace and
arc-
useful in protecting the amplifier should you ever decide to ship it or
move it to another location.
Remove the amplifier from Its shipping carton and packing material.
your
unit is packed into a':aingle carton and is ready to operate with the e-xc*p-'-
tion of a power plug. A power plug that mates with the power socket at the
operating location must be properly installed as described in section 3.33
before the unit can be operate.:.
The following accessories should be included with the amplifier.
1
Instruction Manual I Warranty Card
1 PL259 Coax Connector QF,7 1 Drive Cable (RG58)
J. N type Coax Connector i50
1 Set Fuses
2 Shielded Control Cables
SECTION 3.2 OPERATING LOCATION
The amplifier may be located wherever desired provided there is adequate
air flow from the bottom of the unit up through the top of the amplifier.
Do not restrict the airflow o f the amplifier, and never place it too close
to a wall that might restrict the airflow into the hack: of the unit.
You will require a location that has an appropriate 220 VAC power source. A
location which avoids environmental extremes of heat, humidity, and dust
will keep the amp] i fisrr new looking and assure years of reliable operation.
SECTION 3.3 CABLING
All of the following cables must be connected before operation of the
amplifier.
POWER CABLE -" The amplifier is equipped with a 3-wire AC power cable that
is normally wired to accept 220 VAC, 3 wire, 60 Hz, single phase power .an-
-less
special instructions were given at the time of the order. A factory
modification is required
for 50 Hz operation, or 200 VAC olreration,
or for
2-- wire cur opean operation.
The three wires in the power 16t?le are black, white, and green. The green
wire is chassis ground and the neutral on the 220 VAC plug. The black and
white wires connect the "hot" 220 VAC circuits. A power plug is not sup--
plied becau5e there are many different types of 220 VAC outlets. We sug-
gest that you consult with a local electrician about the proper :oril?ectlor1
5