EarthQuake 600050 Series Operator's Manual Original Operating Instructions page 14

To detach the Tires
To detach the tires, loosen the axle nuts and remove the wheel,
spacer and washer. Reverse instructions to reattach tire. see
fIGuRe 14.
Figure 14: Detaching tires
How to Adjust the Height/Angle of the Handle
Use the cam levers on each side of the handle to adjust the
height of the handle. see fIGuRe 15.
1. Hold the handle with one hand and open both cam levers un-
til the ratchet teeth are disengaged. Do not remove the nuts.
2. Move the handle up or down to the desired position, then align
the ratchet teeth. Make sure both sides of the handle are level.
3. Tighten (lock) the lever.
locked
open
cam
lever
Figure 15: Adjusting the height of the handle. (Lever shown
in OPEN position)
14
handle
ratchet
teeth
Rolling High-Wheel String Trimmer 600050 Series
WARnInG
BefoRe you seT THe HeIGHT of THe cuT, sToP THe
enGIne. WAIT foR All moVInG PARTs To sToP. Al-
loW THe enGIne To cool And dIsconnecT THe
sPARk PluG WIRe.
How to set the Height of the cut
The height of the cut can be set from 1-1/2 inches to three (3)
inches. The recommended cutting height for the average yard
is two (2) inches. see fIGuRe 16.
1. Use the L-handle wrench found in the parts bag to loosen the
socket head cap screws shown in the figure below.
NOTE: There are two socket head cap screws.
2. Set the trimmer head at the desired height.
3. Tighten the socket head cap screws.
height of cut
positions
socket head
cap screws
height guide
Figure 16: Setting the height of your cut.
Get parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
Operator's Manual
trimmer head
L-handle
wrench