Summary of Contents for Infinity Compositions Overture OVTR 2
Page 1
® Models OVTR 2, OVTR 3 3-Way Full-Range Floorstanding Speakers Owner’s Manual OVTR 2 Part #331250 – USA 120 Vac Only OVTR 3 Part #331251 – USA 120 Vac Only...
Page 2
DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THIS INFINITY PRODUCT IS DESIGNED FOR (USA) 120 VOLT USE ONLY! FOR DETAILED SAFETY PRECAUTIONS, PLEASE SEE THE ENCLOSED LEAFLET “IMPORTANT SAFETY INSTRUCTIONS” (P/N 330100-001).
(4) Locking Nuts (4) Nylon Domes (1) Wrench (2) Spare 5 A (250 V) Fuses for OVTR 2 or (2) Spare 7 A (250 V) Fuses for OVTR 3 Owner’s Manual (P/N 331350-001) and Warranty Registration Card You may also need the following tools and supplies:...
Page 4
2 Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual NSTALLING Compositions Overture OVTR 2 and OVTR 3 speakers use dual-purpose feet with spike and round ends for carpeted or hard-surface floors. Refer to Figures 1 and 2 as you perform the following steps: 1.
Page 5
4. If needed, adjust the feet so each speaker is level and then tighten each nut with the enclosed wrench. To protect hard surfaces (e.g., wood floors), thread a nylon dome onto each round end (see Figure 2). Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual 3 Bottom Of Speaker Locking Nut ⁄...
Moreover, you can add a subwoofer for deep bass impact on sound effects and music. Contact your local Infinity dealer for recommendations on adding these home theater speakers to your system.
(below 100 Hz) away from the center-channel speaker to the front left and right speakers. Compositions Overture OVTR 2 and OVTR 3 speakers have integrated powered subwoofers and only require one set of output leads for the left and right channels.
Page 8
On” LED (see Figure 6 below) glows red when the amplifier is the stand- by mode and green when the amplifier is on. If on/off switching is desired, connect the OVTR 2 ’s (or OVTR 3) ac power cord to an ac switched outlet. If you plan to leave for an extended period of time (e.g., vacation), switch the system off (or unplug the ac...
3. Remove the old fuse and replace it with new one having the same value and rating. For the OVTR 2, use a 2AG 5A SB 250V fuse. For the OVTR 3, use a 2AG 7A SB 250V fuse.
No sound from Power cord not speaker system; connected; no ac power power LED not on Blown fuse *If you need further assistance, contact your local Infinity retail dealer. PEAKER YSTEM OLUTION Move speakers away from walls Rotate BASS control towards “1”...
Page 12
RIVE NITS MPLIFIER UILT IN POWER AMPLIFIER FOR FREQUENCY SECTION IMENSIONS (also see Figure 7 on page 11) 10 Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual PECIFICATIONS Frequency Range: Sensitivity: Impedance: Maximum Peak Output: Amplifier Requirements: Low Frequency: Mid Frequency:...
Need help?
Do you have a question about the Compositions Overture OVTR 2 and is the answer not in the manual?
Questions and answers