Infinity CLASSIA PSW310W Owner's Manual page 6

S C
YSTEM ONNECTIONS
Choose either Wireless or Wired connection, then follow the appropriate instructions.
WIRELESS
Connecting the Subwoofer for Wireless Applications
DC18V
Step 1.
Connect a subwoofer cable from the subwoofer or LFE output of
your receiver to the Sub In
Step 2.
Plug the transmitter module into the wall outlet, and connect the
included power supply and power cord to the transmitter
sure the Transmitter Antenna
Step 3.
Set the ID code on the transmitter and subwoofer
the same position, as described on page 4. When connected properly,
the LED ¢ on the rear of the subwoofer will be orange.
Step 4.
Set the Low-Pass Selector ∞ to the "Off" position.
NOTE: Some receivers have two subwoofer outputs. In that case, use
either one of the connectors.
3 INFINITY CLASSIA PSW310W (120V)
ID
CODE
Sub In
1 2 3 4
on the transmitter.
. Make
is extended upward.
and §
( )
WIRED
Connecting the Subwoofer for Wired Applications
If you have a Dolby ® Digital or DTS
a low-frequency effects (LFE) or subwoofer output:
Wireless
ID Code
L
Sub In
If your receiver/processor does not contain a Dolby Digital
or DTS processor but has subwoofer outputs:
to
NOTE: If your receiver/processor has only one sub out, you
may use either the L or R input.
® receiver/processor with
Level
Crossover
[Hz]
O O ff ff O O n n
Low-Pass Low-Pass
Green: Sub On
Red: Standby
Orange: Sub On and
Wireless Link Active
R LFE
Line In
Level
Crossover
Wireless
O ff O n
ID Code
Low-Pass
L R LFE
Sub In Line In
[Hz]
Green: Sub On
Red: Standby
Orange: Sub On and
Wireless Link Active