Advertisement
Quick Links
GPS Watch User's Manual
Please read this user's manual carefully and always use correct operation
methods to prevent any possible errors.
This user's manual is for reference only. If some contents and operation steps
are inconsistent with those for the actual product, the latter will prevail.
The defaulted password of this product is 0000.
1
Advertisement
Summary of Contents for Easy Gps watch
- Page 1 GPS Watch User’s Manual Please read this user’s manual carefully and always use correct operation methods to prevent any possible errors. This user’s manual is for reference only. If some contents and operation steps are inconsistent with those for the actual product, the latter will prevail.
- Page 2 I..Appearance and Buttons Button Key Function Power On/Off Power switch-on and off For voice transmission during a call Charger Connector For power charger Mode-Switch Time / GPS information interface switch Number 1 Predetermined number 1 SOS Key Emergency aid (SOS button) Number 2 Predetermined number 2 Speaker...
- Page 3 III.. Operation Method of Basic Functions 1.Location Inquiry In order to activate the GPS watch, you must first install the SIM card into the watch. After the watch is turned on, you must first send a single SMS message to the watch with number “1” entered into the message.
- Page 4 Step 2: Click the terminal of the ward, then the location of the ward will be displayed on the map. 2. Setup of Centre Number Set the centre number by SMS through the mobile phone, after the setup is successful, then the mobile phone that sending the SMS will receive the “&710&successful setting&&”...
- Page 5 then the ward terminal will automatically call back to the mobile phone of the guardian and the guardian may hear the sound of the surroundings within 10m around the ward. SMS format: 5550000 Remarks: 0000 is the initial defaulted password and in practice the password could be set by the user.
- Page 6 After this command is executed, APN will be internet; the login user name is guest and login password is a1234. Note: The default APN of this product is CMNET. 11. Setup of Server Address Command Format: #803# Fixed IP address# port number#4-digit password## This command is used to set GPRS center server address, which could be fixed IP number, like num1.num2.num3.num4……as well as domain name with the length less than 64.
- Page 7 IV.. Troubleshooting If there is a problem in you watch, please refer to the help information in the following table. If you still can not solve the problem after referring to the table below, please contact your dealer. Failure Possible Cause Solution The battery is out of Charge the battery...
- Page 8 Notices: This device is of non-waterproof design; The device shall be supported by the GSM/ GPRS network; Make sure that there is sufficient balance in the SIM card account, so as to avoid inconvenience; The device can not work under power-off state or outside the service area, even you are a registered user;...
Need help?
Do you have a question about the Gps watch and is the answer not in the manual?
Questions and answers