GE Café CS980SN1SS Technical Service Manual page 22

Lock Assembly Removal
The lock assembly is attached to the front of the range by two T-15 Torx screws. To replace the door lock it
is necessary to place the control panel in the service position (See
insulation, and two 1/4-in. hex-head screws and the lock assembly cover.
Door Lock Assembly (top view shown with insulation and cover removed)
Door Lock Assembly (removed, rear view shown)
Lock Motor
Switch #1
C
Switch Function
1 Door Lock
2 Door Unlock
3 Cooling Fan Motor Speed
Hi speed in clean, Low speed
in other modes
4 Lower oven and all surface
unit lockout in Clean cycle
Caution: It is possible to reconnect the switch wiring incorrectly to the lock assembly. When reconnecting
the wiring, make sure it is properly connected to the lock assembly before turning the power back on.
NO
Door UnLocked
C - NO open
C - NO closed
C - NO closed
C - NC open
C - NO closed
C - NC open
– 22 –
.), remove the lock assembly
Control Panel
C
NO
C
NO
NC
C
NO
NC
Door Locked C
C - NO closed Yellow
C - NO open Yellow
C - NO open Gray/Red
C - NC closed
C - NO open Red
C - NC closed
Switch #2
Switch #3
Switch #4
NO NC
Gray N/A
Orange N/A
Black Blue
Violet Brown