Wash Cycle Table - Silhouette Instruction Manual

WASH CYCLE TABLE

Program
Cycle
Intensive
Normal
Economy
Rinse
Glass
Rapid
Pre-rinse
ERROR CODES
Codes Meanings
Low inlet water pressure.
E1
Excessive draining time.
E2
Water temperature increasing too slow,
E3
not reaching required temperature.
Over filled.
E4
Failure of Temperature Sensor
E6
Failure of Temperature Sensor
E7
WARNING: WHEN AN OVERFLOW OCCURS;
This dishwasher is designed to detect water overflow conditions. If an overflow condition occurs, the dishwasher will
automatically stop operating and display the corresponding "E4" fault code in the LCD window. The overflow container
which is monitored by a safety switch has been filled with water and must be manually emptied before normal dish-
washer operations can resume. Refer to "Overflow Conditions" on page 13 for instructions on how to correct this.
Cycle Selection
Information
Pre-Rinse 50 o C(122 o F)
For the heaviest soiled
loads, such as pots, pans,
casserole dishes and
dishes that have been sit-
ting with dried food on
them for a while.
For normally soiled loads,
such as; pots, plates,
glasses and lightly soiled
pans. This is the standard
daily cycle.
For lightly soiled loads,
such as; plates, glasses,
bowls and lightly soiled
pans.
For dishes that need to be
rinsed and dried only.
A shorter wash for lightly
soiled loads.
For lightly soiled loads,
such as; glasses, crystal
and fine china.
Pre-wash of dishes, pots
and pans while waiting for
the load to be completed
after subsequent meal.
Description
of Cycle
Pre-Rinse
Wash 50/60/70 o C
(122/140/158 o F)
Rinse
Rinse 65/70/75 o C
(149/158/167 o F)
Drying
Pre-Rinse #1
Pre-Rinse #2
Wash(50/60 o C)
(122/140 o F)
Rinse
Rinse(65/70 o C)
(149/158 o F)
Drying
Pre-Rinse
Wash(50/60 o C)
(122/140 o F)
Rinse
Rinse(65/70 o C)
(149/158 o F)
Drying
Rinse
Rinse(60/70 o C)
Drying
Pre-Rinse
Wash(40/50 o C)
(104/122 o F)
Rinse
Rinse(60/70 o C)
(140/158 o F)
Drying
Pre-Rinse
Wash(40/50 o C)
(104/122 o F)
Rinse
Rinse(55/60 o C)
(131/140 o F)
Pre-Rinse
Possible Causes
Line faucet is not opened
The installation position of the drain pipe is too high.
Malfunction of temperature sensor or of heating element.
Too much inlet water.
Short circuit or break of temperature sensor.
Open circuit or break of temperature sensor.
5
Detergent Rinse
pre/main Agent
5/20 gr.
5/20 gr.
20 gr.
15 gr.
15 gr.