Advertisement
Quick Links
CS1505
Device Overview
Cadence Sensor
Sensing Point
Test Key
Battery Cover
INSTALLATION
1
Install Cadence Magnet Set
Install Cadence Magnet on left crankarm near pedal
as shown. Do not tighten zip ties completely to
allow magnet placement. Use Extension Rubber for
proper distance adjustment
2
Install Sensor
3
Install Wheel Magnet Set
For Round Spokes
For Bladed Spokes
Unscrew the wheel magnet
to install on spoke.
Speed & Cadence Sensor
Speed Sensor
Sensing Point
Cadence Magnet Set
for crankarm
Cadence
Magnet
Extension
Rubber
Cadence Sensor
Sensing Point
Align Cadence Magnet with Cadence Sensor
Sensing Point as shown. Proper distance between
Cadence
sensor and magnet should be less than 10 mm
Magnet
Pre- t Sensor and Rubber Bracket on left rear
chainstay (non-drive side) and trim excessive
rubber from bracket. Ensure the battery cover is
facing up. Install zip ties loosely to allow sensor
placement.
Align Wheel Magnet with Speed Sensor Sensing
Point as shown. Proper distance between sensor
and magnet should be less than 10 mm. Use screw
driver for proper distance adjustment.
User's Guide
Wheel Magnet Set
Rubber Bracket Set
Zip Tie
Rubber
Bracket
Top View
IMPORTANT NOTE
Top View
IMPORTANT NOTE
Zip Tie
Advertisement
Summary of Contents for Jarv CS1505
- Page 1 CS1505 Speed & Cadence Sensor User’s Guide Device Overview Cadence Magnet Set Cadence Sensor Speed Sensor Wheel Magnet Set for crankarm Sensing Point Sensing Point Rubber Bracket Set Cadence Zip Tie Zip Tie Magnet Rubber Bracket Extension Rubber Test Key...
- Page 2 CS1505 Speed & Cadence Sensor User’s Guide Adjust Sensor and Magnet Sets GAP < After entering Test Mode and tested successfully, use the needle nose plier to help tighten the zip tie and make sure the Sensor is securely installed on the left rear chainstay.