Related Manuals for Alvarez System 600T MK II
Summary of Contents for Alvarez System 600T MK II
- Page 1 Alvarez Instruments A Division of St. Louis Music, Inc. 1400 Ferguson Avenue St. Louis, MO 63133 Tel: 314-727-4512 www.alvarezgtr.com...
-
Page 2: Internal Chassis Controls/Connections
Refer to the front panel diagram on the next page Some features of the System 600T MK II will only operate when an to familiarize yourself with the various control additional pickup/microphone is used. -
Page 3: Front Panel Controls And Features
The Alvarez System 600T MK II has been designed to accurately r e p r o d u c e switch (In/Out) to correct the polarity. the natural sound of an acoustic guitar when used with a wide variety of Note: If only one input is used, this switch will have no effect. -
Page 4: Specifications
0.05% Power Consumption: 2.2mA(Tuner OFF) The System 600T MK II features a built-in chromatic digital tuner. 8.5mA- 12.5mA(Tuner ON) The tuning function can be accessed at any time, whether the guitar is plugged in, or not. To engage the tuner, press the TUNER ON/OFF...
Need help?
Do you have a question about the System 600T MK II and is the answer not in the manual?
Questions and answers
What size are the piezo input jack I noticed it was smaller than the auxiliary port
The piezo input jack on the Alvarez System 600T MK II is 2.5mm mono.
This answer is automatically generated
My tuner seems to be off ie: my E string shows up as an F, the A is on track but back to different readings on other strings while guitar is in perfect tune from other sources and by ear
The Alvarez System 600T MK II tuner may show incorrect readings for the E and other strings if the guitar is not properly connected or if the tuner is not engaged correctly. Also, if the note is sharp or flat, the red LEDs will blink, and only when the pitch is correct will the green LED light. Additionally, if the battery is low (indicated by a dim LED or distorted signal), the tuner may not function accurately.
This answer is automatically generated
I install a battery and the red led light comes on and stays on
The red LED light stays on after installing a battery in the Alvarez System 600T MK II if the battery is weak or low on power. When the battery voltage drops, the LED may remain dimly lit, and the signal may become distorted. To resolve this, remove the chassis and replace the battery with a new one.
This answer is automatically generated