Hyundai H-DVR09HD Instruction Manual page 3

Car video recorder
Table of Contents

Advertisement

Available languages

Available languages

Right panel
4
5
6
4.
button
5. MODE button
6.
button
7. HDMI output
Left panel
8
9
10
8.
button
9.
button
10.
button
11. USB port
Not indicated: RESET hole button (bottom),
Memory card slot (back side)
Operations
Mounting
• Insert the fixing pins on the top of the
stand into the bracket holding holes in the
bottom of the unit and move the unit backward
until a click to fix it tightly to the bracket.
• Press the suction cup to a surface in the
car, then push the pressure valve down. Make
sure the stand is fixed properly to the surface.
• You can adjust the angle of the stand by
loosening the upper and lower washers and
bending the assembly knots.
• To unmount the stand, lift the pressure
valve, then lift the plastic ear on the suction cap.
7
its USB port to the PC with the supplied USB
cable; or connect it to a car lighter socket
with the supplied car adapter. The power icon
indicates the remaining battery power.
you can rotate the display in one plane relative to
the hinge axis 180
11
memory card into the memory card slot of this
unit until a click. Insert the card with correct side.
"FULL HD" will be shown in the left upper
corner of the display showing that the unit is
ready for recording.
Gb. For correct and satisfactory operation,
licensed MicroSD memory cards of famous
brands should be used with this unit. Avoid
using memory cards of unknown brands.
button to start recording video. The unit will
save video files automatically after each 2, 5
or 10 minutes. When the memory card is filled,
old files will be deleted and the new files will
be recorded instead. Press
and to continue recording.
out.
flash mode.
unit. Connect this unit to a car lighter socket to
start charging it. The unit will be turned on and
start video recording at the same time when
your car engine is started. It would save video
files automatically and be switched off after the
car is stopped.
Instruction Manual
Power and charging
To charge the battery of this unit connect
on the upper right corner of the display
Rotary display
To improve the display angle for viewing it,
leftwards and 90
0
Get ready for record
• Before you start recording, insert a MicroSD
• Press
button to switch the unit on.
MicroSD capacity supported: up to 32
Recording
• When the unit is turned on, press
• Press
or
button to zoom in or
• Press repeatedly
• You can record video while charging the
rightwards.
0
button to stop
button to select a
3

Advertisement

Table of Contents
loading

Table of Contents