Table of Contents
Advertisement
HINT FOR LAMP-CHANGE
Before removing the bulb access panel, pull out
the main-plug. Change the faulty bulb and secure
the bulb access panel. Plug the cord back in and
check operation.
F. CHANGING POWER SUPPLY CORD
(See exploded view on page 15)
(1) Unfasten 1 screw for ground and pull out the
2 wires of the power cord from the terminal plate.
(2) Remove 1 screw for the bottom bracket of the
cord bushing.
(3) Install the new power supply cord with the
reverse procedure of above (1) to (2).
WARNING:
For changing the power supply cord, never use
other than the following.
Key No. Order No.
5
617 140 1318
6
617 140 1332
7
617 140 1349
G. REMOVING CERAMIC TRAY ASS'Y
(See Fig.12 )
(1) Take off the cabinet.
(2) Put (insert) a screwdriver in the 9 mm diameter
hole located at the lower hinge of left side of the
oven cavity. Push the tray up with the screw-
driver.
(3) Open the door and take out the tray very care-
fully.
H.REMOVING DOOR
Remove 2 hex nuts securing the upper hinge,
remove 3 hex nuts securing the lower hinge and
remove 1 special screw securing the door arm
(located at the bottom of the door sash).
Parts Name
Power cord Ass'y
Cord bush
Bottom bracket
Door
Hole
Screw driver
Figure 12
NOTES
- After replacing the door, be sure to check that the
interlock switch, the door sensing switch
and the interlock monitor swich operate normally.
(See pages 1 and 6)
- After replacing the door, check for microwave ene-
rgy leakage with a leakage detector. Microwave
energy leakage must be below the limit of
5mW/c ‡u. (For US)
- After instaling the door, check for microwave
energy with a leakage detector and confirm that the
leakage is the below the limit of 1 mW/cm
waterload),5 mW/cm
(at 275cc water load without cabinet) . (For CANADA)
I.HOW TO RESET THE MEMORY OF ACCUMU-
LATIVE COOKING TIME
1. Push the keys step by step as follows,
" CLEAR ", " TIME ", " 8 ", " 8 ", " 8 ", " 1 "
" START ", " START ".
The display will show accumulative cooking time
in display window.
2. Then push the keys as follows.
" 0 ",
" MEMORY ".
The Memory of Accumulative cooking time will be
cleared.
J.RELEASING TYPE CONNECTOR
This oven is provided with locked type connectors.
When you remove a connector, pull the connector while
releasing the lock by pressing "A" point shown below.
Do not pull the wire of the connector.
Connector:
S1, S2, S102, S104, S105 (Figure 13)
A
Figure 13
Pull connector case (Never pull the wire)
Figure 15
- 14 -
2
(at 275cc
2
(at no load) and 5 mW/cm
A
Figure 14
2
Advertisement
Table of Contents
