Panasonic WV-NF302 Installation Manual page 31

Step 1
Start the Panasonic IP setting software.
Step 2
Click the [IP setting] button after selecting
the MAC address/IP address of the camera
to be configured.
Note:
When using a DHCP server, the IP
address assigned to the camera can be
displayed by clicking the [Refresh] but-
ton of the IP setting software.
Step 3
Complete each network setup item and click
the [Apply] button.
Note:
When using a DHCP server, it is possible
to set "DNS" to "Auto".
Important:
• It may take around 30 seconds to com-
pletely upload the settings of the camera
after clicking the [Apply] button. The set-
tings may be invalidated when the 12 V
DC power supply is cut or when the LAN
cable is disconnected before completing
the upload. In this case, configure the
settings again.
• When using a firewall (including soft-
ware), allow access to all UDP ports.
31