Hyundai H-1526 Instruction Manual page 3

Important safeguards
• The instruction manual contains
important operating and maintenance
instructions. For your safety, it is
necessary to refer the manual. Keep the
manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration,
direct sunlight, too high or low
temperature or humidity.
• If you are not going to use the unit
within a long period of time, remove the
batteries to avoid their leakage.
• Do not disassemble the unit
yourselves. Refer servicing to qualified
service personnel.
Power supply
Battery operation
• Insert 1x9V battery (not included)
to the terminal inside the battery
compartment. Your set will not work
normally from the battery supply, but
there is now the advantage that, in case
there is a mains current failure, your clock
will continue to work. The clock display
will not light up, the clock time will be held
in the clock memory by the battery back-
up system.
This enables you to move the set
from place to place without re-setting
the clock every time. The battery back-
up system is only meant to be used
from short temporary power failures.
For longer durations the battery may
become exhausted or there may be some
deviation in accuracy.
• When the battery is exhausted,
Instruction manual
it should be removed from the set to
prevent leakage. If you do not wish
to take advantage of the battery
back-up system, your set will work
normally without a battery. However, if
disconnected from the mains, the clock
figures will flash when the mains are re-
connected and you must re-set the clock.
AС operation
• The appliance is for household use
only.
• Before the first connecting of the
appliance check that voltage indicated on
the rating label corresponds the mains
voltage in your home.
• Insert the plug into the power supply.
• The set is now working as an electronic
clock. Figures will blink on the display,
showing that you should set the clock.
Setting the clock
• Press and hold TIME button.
• Do not release TIME button; press
HOUR button or MINUTE button to set
the clock display to the correct time.
• Release all the buttons when finished
the setting.
Radio operation
Tuner operations
• Slide AUTO/OFF/ON switch to ON
and turn on the volume.
• Slide AM/FM switch to AM or FM
position.
• Adjust the program using TUNING
regulator.
• Use VOLUME regulator to adjust
3