Starting A Washing Programme; Wash Cycle Table; Turning On The Appliance; Change The Programme - Primera PR60DWH User Manual

Table of Contents

Advertisement

6. Starting a Washing Programme

Wash cycle table

Cycle Selection
Program
Information
For the heaviest soiled loads,
such as pots, pans, casserole
dishes and dishes that have
been sitting with dried food
Intensive
on them for a while.
For heavy soiled loads,
such as pots, plates, glasses
and lightly soiled pans.
standard daily cycle.
Heavy
For normally soiled loads,
such as pots, plates, glasses
and lightly soiled pans.
Normal
Standard daily cycle.
(AS/NZS 2007.1)
For dishes that need to be
rinsed and dried only
Rinse
A shorter wash for lightly
soiled loads that do not
Rapid
need drying.
To rinse dishes that you
plan to wash later that day
Soak
AS/NZS 2007.1:This programme is the test cycle. The information for comparability test
in accordance with AS/NZS.2007.1, as follows:
- Capacity: 12 settings
- Position Upper basket: upper wheels on rails
- Rinse aid setting:5
NOTE:
We recommend you open the door slightly 50mm to assist in drying of the dishes after
every wash.

Turning on the Appliance

Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent .
2. Insert the plug into the socket. The power supply is 240V AC 50 HZ, the specification of the socket
is 12 A 240 VAC.50 HZ.
12
Running
Energy
Description
Detergent
Time
Pre/main
(kWh)
of Cycle
(min)
Pre-wash(40 )
Main wash(55 )
Rinse
5/25g
145
1.20
Hot rinse(65 )
Drying
Main wash(60 )
Rinse
Rinse
5/25g
135
1.15
Hot rinse(65 )
Drying
Main wash(45 )
Rinse
5/25g
112
0.73
Hot rinse(49 )
Drying
Pre-wash
67
0.75
Hot rinse(70 )
Drying
Main wash(40 )
20g
50
0.50
Hot rinse(49 )
Pre-wash
8
0.01
Make sure that the water supply is turned on to full pressure. Open the door, press the ON/OFF
button, Press the "program." button to select a desired "Wash cycle". (See the section entitled "Wash
Cycle Table".)
With a little force to ensure the door is properly closed.
Water
NOTE:
A click could be heard when the door is closed perfectly.
(L)
When the washing is over, you can shut off the switch by pressing ON/OFF button.

Change the Programme.

15.5
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
15.0
entitled " Fill in the Detergent " ).
Open the door, Press current prog. button more than three seconds to cancel the programme, then
you can change the programme to the desired cycle setting (see the section entitled "Starting a wash
cycle. . . " ). Then, close the door.
NOTE: If you open the door when washing, the machine pauses and warning alarm rings, the display
11.8
appears E1. When you close the door, the machine will keep on working after 10 seconds.
The 6 programme lights show the state of the dishwasher:
a) All program lights off --> stand by
b) One of the program lights on --> cycle running
7.5
c) One of the program lights blinking --> pause
NOTE:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.
7.5

Forget to Add Dish

A forgotten dish can be added any time before the detergent cup opens.
4.0
1 Open the door a little to stop the washing.
2 After the spray arms stop working, you can open the door completely.
3 Add forgotten dishes.
4 Close the door, the dishwasher will work after ten seconds.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher. The status indicator lights up , only in this case the programme has ended.
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
.
Open the door carefully. Hot steam may escape when the door is opened!
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pr60dsx

Table of Contents