Power Supply; Turn On / Off The System; Adjusting The Sound; Clock Adjustment - LENCO SCR-98 MP3 Instruction Manual

POWER SUPPLY

USING AC
Before use, check that the rated voltage of your unit matches
your local voltage.
Note: Plug is used as the disconnect device.
The disconnect device shall remain readily operable.
USING BATTERIES
Disconnect the AC power cord from the AC inlet of the
unit. Battery power is cut automatically by the cord while
it is connected.
battery door

TURN ON / OFF THE SYSTEM

Press the POWER button to turn the audio on.
To change the audio mode between CD, RADIO AND TAPE ,
set the FUNCTION switch while the power is on.
The audio mode is displayed.
Turn off the unit by pressing the POWER button. The current
time is shown on the display.

ADJUSTING THE SOUND

CLOCK ADJUSTMENT

The clock is displayed on LCD display at standby mode.
1. Press the PROGRAM / CLOCK-ADJ. button,
2. Press the
3. Press the PROGRAM / CLOCK-ADJ. button, the hour digit flash.
4. Press the NEXT or BACK to adjust hour digit.
5. Press the PROGRAM / CLOCK-ADJ. button, the minute digit flash.
6. Press the NEXT or BACK to adjust minute digit.
7. Press the PROGRAM / CLOCK-ADJ. button again, the correct time is
shown on display.
CD30MP3 LENCO SCR-98MP3 ENG TCD14 4
TO ADJUST THE VOLUME
VOLUME
MIN. MAX.
VOLUME
on LCD display at standby mode.
NEXT or BACK to select 12 hours or 24 hours display.
When the volume decrease, or the sound distorts, replace
all of the batteries with new ones.
Insert eight UM-2 ( size C ) batteries.
POWER
WHEN RECORDING
The VOLUME control may be adjusted with no effect on
the recorded signal.
FOR PRIVATE LISTENING
Plug in headphones (ø3.5 mm stereo mini-plug) to the
PHONES jack.
When headphones are plugged in, the speakers are au-
tomatically disconnected.
the hour digit flash.
GB 2
To AC socket
To AC outlet
LCD display
CLOCK-ADJ.
5/4/2013 10:56:41