Advertisement
1.
Open the packet and select the location where you would like to install the camera.
Take the mounting bracket off the camera.
2. Slightly drill the supplied three screws into the three round holes on the mounting bracket and
rotate the bracket clockwise until the
Tighten the fixing screws to secure the mounting bracket to the ceiling.
3. Drill a hole in the middle circle and let the power and video line go through.
4. Mount the body onto the mounting bracket and rotate it until it clicks to secure.
Adjust the camera to the correct position and test the camera to make sure it is working properly.
1.
DC12V Input Terminal
Connect the power terminal of the camera to a 12V DC regulated power supply.
Note: Please use the correct power adaptor, DC12V (regulated), to operate this unit.
The power tolerance of this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this
unit.
2. Video Output Connector (VIDEO OUT)
Connect the camera video output and the monitor video input with 75 coaxial cable.
1. No picture after providing power
•
May be the power supply voltage abnormity, please
check the power supply voltage and pole whether
exactitude.
•
Please check all the connecting cable and monitors
whether be connected correctly or not.
2. The picture level direction have flowing interference ripples
•
May be caused by the power supply AC ripples, it need
filter the wave of the power supply.
•
Check the monitor and peripheral equipments used.
The company shall not be liable for any damages arising out of any improper use, even if we have been advised of the possibility of such damages.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of
uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of
electric shock to persons.
This exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying the appliance.
The crossed-out wheeled bin mark symbolizes that within the European Union the product must be collected seperately at
the product end-of-life. This applies to your product and any peripherals marked with this symbol. Do not dispose of these
products as unsorted municipal waste.
CE Mark
This apparatus is manufactured to comply with the radio interference.
The company does not warrant that this manual will be uninterrupted or error-free. We reserve the right to revise or remove
any content in this manual at any time.
screws are wedged into the narrower chase.
TROUBLE/SOLUTION
RISK OF ELECTRIC SHOCK
To reduce the risk of electric shock, do not expose this apparatus to rain or moisture.
Only operate this apparatus from the type of power source indicated on the label.
INSTALLATION
CONNECTION
3. The picture background color changes continuously
•
The fluorescent lamp's electromagnetic field cause color roll.
•
This is proper phenomenon of the cameras.
•
Reduce the fluorescent lamp numbers or increase the
distance between the camera and the fluorescent lamps
can improve it.
•
Use power supply external sync. camera can solve it.
4. The picture smear too mass
•
The power supply's voltage unstable.
•
Connecting cables not connect correctly or have high
impedance.
CAUTION
CAUTION:
Advertisement
