Philips DVP3350V Service Manual page 120

DECK MECHANISM DISASSEMBLY
DISC CLAMP ASSEMBLY
PLATE CLAMP
MAGNET CLAMP
CLAMP UPPER
1.Main Base (Fig. 5-1)
1-1. Clamp Assembly Disc
1) Place the Clamp Assembly Disc as Fig. (A)
2) Lift up the Clamp Assembly Disc in direction of
arrow(A).
3) Separate the Clamp Assembly Disc from the Holder
Clamp.
1-1-1. Plate Clamp
1) Turn the Plate Clamp to counterclockwise direction and
then lift up the Plate Clamp.
1-1-2. Magnet Clamp
1-1-3. Clamp Upper
MAIN BASE
(Fig. A)
HOLDER
BASE MAIN
Fig. 5-1
TRAY DISC
BASE MAIN
LEVER
BASE MAIN
BOTTOM SIDE VIEW
2. Tray Disc (Fig. 5-2)
1) Insert and push a Driver in the emergency eject hole(A)
at the right side, or put the Driver on the Lever(B) of the
Gear Emergency and pull the Lever(B) in direction of
arrow so that the Tray Disc is ejected about 15~20mm.
2) Pull the Tray Disc until it is separated from the Base
Main completely.
5-2
Fig. 5-2