Quantum Qflash Pilot QF9 Operating Instructions Manual

Shoe mount wireless radio commander for qflash 5d-r and tri

Advertisement

Quick Links

F
tested to comply with FCC standards
CANADA : 3707A-QFPILOT
FCC ID: CEXQFPILOT
This device complies with Part 15 of the FCC Rules and with
RSS-210 of Industry & Science Canada. Operation is subject
to the following conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference
received including that which may cause undesired operation of
the device
IMPORTANT – CAUTION
Changes or modifications to this equipment could void your authority to
use this product under the equipment authorization granted by the
regulating agencies
Quantum Instruments Inc.
10 Commerce Drive, Hauppauge NY 11788-3968 USA
Tel: 1-631-656-7400 Fax: 1-631-656-7410
P667web-English
Qflash PILOT
www.qtm.com
®
Qflash
Shoe Mount Wireless Radio
Commander for Qflash 5d-R and
TRIO

Operating Instructions

Quantum Instruments
Designed and manufactured in the USA
QF9
Pilot

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Qflash Pilot QF9 and is the answer not in the manual?

Questions and answers

Summary of Contents for Quantum Qflash Pilot QF9

  • Page 1: Operating Instructions

    tested to comply with FCC standards CANADA : 3707A-QFPILOT FCC ID: CEXQFPILOT ® Qflash Qflash PILOT Pilot This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry & Science Canada. Operation is subject to the following conditions: 1) this device may not cause harmful Shoe Mount Wireless Radio interference, and 2) this device must accept any interference received including that which may cause undesired operation of...
  • Page 2: Table Of Contents

    PILOT Display Symbols ISO from camera Battery status F/number from camera F5.6 ISO 200 F5.6 FILL P1-P8 SELECT CH. 7 Channel of TEST OPTIONS internal radio Table of Contents 1. Introduction 2. Getting started 3. Basic Navigation and Options 4. Choosing the right mode 5.
  • Page 3: Getting Started

    2.3 Connecting PILOT to a Camera 2. Getting Started Loosen Shoe lock until metal “foot” protrudes fully. 2.1 Powering the PILOT The Pilot can be powered by 4 “AA” batteries, or Quantum Turbo Battery including Turbo, Turbo 2x2, Turbo Compact, Turbo SC, Turbo AC and Turbo Z. Slide PILOT into camera hot shoe.
  • Page 4 3.1 P1-P8 The Pilot can store up to eight of your favorite settings. 3.5 Options Enter the Program mode by pressing the P1-P8 soft key. See section 8 for details on using the program mode. Press the OPTIONS button to enter the options set up menu.
  • Page 5: Choosing The Right Mode

    Once the setting is highlighted use the Left (-) and Right (+) 3.5.3 Sync type buttons to change that setting. R, HSS Below is a list of modes, their uses and the setting used in that mode. There are three settings for the sync. F –...
  • Page 6: Setting Up A Remote Qflash 5D-R

    Step 2 4.3.1 A.Fill mode setting Set the channel on the Free X Wire to the channel you will be using on the Pilot. Turn all four zones on. In the Auto Fill (A.Fill) mode you can set the exposure of the remote flash from 3 stops below to 2 stops above the camera setting.
  • Page 7: Program Mode

    7. Program mode An estimate of repair cost on out-of-warranty merchandise may be forwarded if you desire. This will require that we contact you for approval before proceeding and will delay return of your equipment. For fastest repair time, you may pre-approve repairs up to the limit of $85 with your The Program mode allows you to store your favorite settings and set-ups and then quickly recall credit card.

Table of Contents