Function Buttons - Danby DPA120B1WB Instructions Manual

Function Buttons

1
3
4
5
Model: RG5 1 4 I 6 B / G
1
Push this button to decrease the indoor temper-
ature setting by 1°C (2°F) increments to 30°C (86°F)
2
Push this button to increase the indoor temper-
2
6
ature setting by 1°C (2°F) increments to 17°C (62°F)
7
Press and hold the UP and DOWN buttons at the same
8
time for 3 seconds to alternate the temperature display
9
10
between °C and °F.
11
12
3
MODE Button
C E
Each time the button is pressed, the operation
mode changes in the following sequence:
AUTO
4
5
Once the recessed RESET button is pressed,
all of the current settings will be cancelled
and the controller will return to default settings.
6
Operation starts when this button is pressed
and stops when the button is pressed again.
7
Used to select the fan speed in four steps:
8
Press this button to activate the Auto-on time
setting. Each time it's pressed will increase the start
time by 30 minute increments, up to 10 hours, then
by 1 hour increments up to 24 hours. To cancel the
Auto-on time setting, just press the button until
the time setting is 0.0.
9
Select this function if you want the unit to maintain
a comfortable setting and save energy while you sleep.
This function is available on COOL, or AUTO
mode only.
TEMP DOWN Button
TEMP UP Button
COOL
Button
Used to stop or start louver movement and
move the airflow direction up/down as desired.
Button
Button
Button
Auto Low Med
Button
Button
4
DRY FAN
High