Anti-Theft System - Panasonic CQ-VX220L Operating Instructions Manual

Anti-Theft System

This unit is equipped with a removable face plate.
Removing this face plate makes the unit totally inopera-
ble.
Remove the Face Plate
q Switch off the power of the unit.
w Hold the top and bottom of the center part of the face
plate and pull it down toward you.
e Pull the face plate toward you.
r Place the face plate into the case and take it with you
when you leave the car.
Install the Face Plate
q Engage the right and left concave parts (A) on the
lower rear side of the face plate with the convex parts
(B) of the main unit.
w Raise and press the face plate toward the main unit
until a click is heard while engaging (A) with (B).
Face Plate Removal Alarm
This alarm sounds to warn you not to forget to remove
the face plate before leaving your car.
This function is activated when
). ( a page 35)
On
Caution
¡ Be sure to follow the procedure mentioned above to mount the face plate appropriately. Improper mounting such
as forcible mounting without engaging the concave parts with the convex parts may cause trouble.
¡ Use caution not to damage the detection switch while mounting the face plate. Failure to observe this may cause
trouble.
¡ Use caution not to apply excessive force to the removed face plate when the plate is carried or stored. Failure to
observe this may cause trouble.
¡ This face plate is not waterproof. Do not expose it to water or excessive moisture.
¡ Do not remove the face plate while driving your car.
¡ Do not place the face plate on the dashboard or nearby areas where the temperature rises high.
is set to
Security Alarm
DIMMER DIM
VOL
POWER
SEL
MUTE SETUP
PUSH
SOURCE
Removable face plate
w
e
q
Detection switch
( B )
( A )
( B )
( A )
w
TILT OPEN
CQ-VX220L
AV1 IN
TUNE/TRACK
10
11
CQ-VX220L