Electrolux EWF107410W User Manual page 22

126.2931.30:- 23/04/10 13:57 Página 48
48 electrolux something not working
Malfunction
The machine fills then
empties immediately:
The machine does not
empty and/or does not spin:
There is water on the floor:
Unsatisfactory washing
results:
The door will not open:
Possible cause
The end of the drain hose is
too low.
The drain hose is squashed
or kinked. E20
The drain pump is clogged.
E20
The the option or
has been selected.
The laundry is not evenly
distributed in the drum.
Too much detergent or
unsuitable detergent
(creates too much foam)
has been used.
Check whether there are
any leaks from one of the
inlet hose fittings. It is not
always easy to see this as
the water runs down the
hose; check to see if it is
damp.
The drain hose is damaged.
Too little detergent or
unsuitable detergent has
been used.
Stubborn stains have not
been treated prior to
washing.
The correct temperature
was not selected.
Excessive laundry load.
The programme is still
running.
The door lock has not been
released.
There is water in the drum.
Solution
Refer to relevant paragraph
in "water drainage" section.
Check the drain hose
connection.
Clean the drain pump.
Disable the option or
Redistribute the laundry.
Reduce the detergent
quantity or use another one.
Check the water inlet hose
connection.
Change it with a new one.
Increase the detergent
quantity or use another one.
Use commercial products to
treat the stubborn stains.
Check if you have selected
the correct temperature.
Introduce into the drum less
laundry.
Wait the end of washing
cycle.
Wait about 2 minute.
Select drain or spin
programme to empty out
the water.