Replacing The Fridge Door; The Water Inlet Hose And Water Filter - Baumatic TITAN4 Instruction Manual

Replacing the fridge door

The water inlet hose and water filter

o The water pressure should be 1.96 – 12.26 bar to allow the
icemaker to operate correctly.
o Care should be taken to make sure that the water inlet does not
come into contact with any hot surfaces.
o The water filter only filters the water; it does not eliminate
bacteria or microbes.
o The water filter life will depend on how often you dispense water
and ice. We recommend that the water filter is replaced at least
every 6 months.
o IMPORTANT: The water inlet MUST be connected to your cold
water supply.
1) Insert the bottom of the fridge door into
the bottom hinge, making sure that the hinge
pin has been inserted into the hole in the
bottom of the fridge door.
2) Insert the back of the top hinge in the
groove on the top of the cabinet. Close the
door fully against the cabinet, and then
make sure that the top hinge pin is fitted
securely into the hole on top of the freezer
door.
3) Reconnect the harness wires and then turn
the hinge fastener clockwise. IMPORTANT:
You should make sure that the hinge fastener
is securely tightened as far as it will go.
4) Place the top hinge cover back into
position and using
tighten it to the top of the cabinet.
a screwdriver, fully
33