Table of Contents
Advertisement
Quick Links
Mail today to –
Fold, stamp and mail, fax to 561-688-0217 or register on the web at www.aquavacsystems.com
Serial #_______________________________________________________MakoShark 2
This registration card must be mailed within 10 days of purchase to secure limited warranty.
Name_____________________________________________________________________________________
Address___________________________________________________________________________________
City________________________________________________State___________Zip ____________________
Date Purchased____________________________________________________________________________
How many Aqua Vac units do you have?________________________________________________________
Is this replacing another pool vacuum?
Purchased from____________________________________________________________________________
City________________________________________________State___________Zip ____________________
The size of my pool is________________________________________________________________________
Have you seen us on the internet? Yes____
Aqua Vac Systems, Inc.
1711 Longwood Road
West Palm Beach, FL 33409
Attn: Warranty Records
(Stamped on the bottom of the base of the unit)
Registration of Warranty
FOR USE IN THE U.S.A. ONLY.
Yes____ No____ If yes, what brand?______________________
No____
PLACE
STAMP
HERE
Advertisement
Table of Contents
Summary of Contents for Aqua Vac Systems Mako Shark 2
- Page 1 PLACE STAMP HERE Mail today to – Aqua Vac Systems, Inc. 1711 Longwood Road West Palm Beach, FL 33409 Attn: Warranty Records Fold, stamp and mail, fax to 561-688-0217 or register on the web at www.aquavacsystems.com Serial #_______________________________________________________MakoShark 2 (Stamped on the bottom of the base of the unit) Registration of Warranty This registration card must be mailed within 10 days of purchase to secure limited warranty.
-
Page 3: Table Of Contents
Owners Manual Contents Safety Precautions General Information Operating Instructions Motor Information Trouble Shooting Preventative Maintenance Parts Ordering Instructions Specifications Machine Assembly/Parts Previously named Aqua Queen Filter Assembly/Parts Accessories The World’s Best Pool Cleaners For More Than 40 Years 1711 Longwood Road, West Palm Beach, Florida 33409 USA Toll Free 1-800-327-0141 •... - Page 4 In the event of a defect, malfunction, or failure of behalf of such first consumer purchaser. your MakoShark 2, or any warranted part to conform with this warranty, Aqua Vac Systems, Inc. may at its WARRANTY REQUIREMENTS sole option and own expense, replace the MakoShark...
-
Page 5: Safety Precautions
SAFETY PRECAUTIONS The MakoShark 2 automatic swimming pool vacuum cleaner has been manufactured to the standards of CSA (Canadian Standards Association) and ETL (Edison Testing Laboratories) with the highest degree of care and concern for safety. We suggest the following safety precautions become part of your pool safety regulations: 1. -
Page 6: General Information
GENERAL INFORMATION You have purchased the finest piece of equipment in the pool cleaner industry. If you treat it as such, your MakoShark 2 automatic swimming pool vacuum cleaner will give you long, sat- isfactory service. We suggest the unit be stored in the original shipping container for safe- keeping during the off-season. -
Page 7: Motor Information
OPERATING INSTRUCTIONS Cont’d. cord, then remove the unit from the water by use of the handle. Allow excess water from the filter to drain into the pool with the MakoShark 2 resting on the edge or coping. Do not leave the machine in the water after disconnecting. -
Page 8: Trouble Shooting
TROUBLE SHOOTING Machine hangs up or hesitates on pool drain: • Order accessory P/N 1730 (raised drain intake assy.) from Service Center or Factory Machine fails to come out of deep end: • Raise sensor bar to allow machine to climb up incline. Machine turns away from curved wall too soon: •... - Page 9 TROUBLE SHOOTING cont’d. • A short in the motor; check the ground fault interrupter. • Unit runs for short distance but stops. Check for overloaded circuit or possible faulty motor. (Do Not Use Extension Cords.) • Motor runs but unit becomes motionless (gear box worm is worn or the drive pin is sheared). Machine tips over backwards before sensing wall: •...
-
Page 10: Preventative Maintenance
PREVENTATIVE MAINTENANCE In order to maximize efficiency and receive long term service of your unit, we suggest the following: • Thoroughly rinse entire unit after use. • Clean filters thoroughly after each use—a clogged filter can decrease efficiency dra- matically. •... -
Page 11: Specifications
SPECIFICATIONS MOTOR: Type Submersible Gallons Circulated 40 GPM/2400 GPH Voltage 110/115 Volts 220/240 Volts (Export Only) Frequency 60 Cycle-50 Cycle Speed 1725/1425 RPM Bearing Ball Bearing Housing Aluminum Anodized Motor Seals Double Lip Wave Overload Protection Thermal Overload Electrical Cord #l6 Wire Encased in Flotation Jacket;... -
Page 12: Machine Assembly/Parts
1993 TO PRESENT... -
Page 14: Filter Assembly/Parts
HOOD & FILTER ASSEMBLY 1993 TO PRESENT... -
Page 15: Accessories
ACCESSORIES Part #99385 Caddy Cart Available as option... -
Page 16: Longwood Road, West Palm Beach, Florida
For small and large commercial pools ® The KingShark is designed for commercial pools up to 30x60 and cleans entire pool in less than 3 hours! Community centers, motels and small commercial pools of all varieties agree there’s no faster, easier or more econom- ical way to clean their pools! ®...
Need help?
Do you have a question about the Mako Shark 2 and is the answer not in the manual?
Questions and answers