Mitsubishi Electric MSZ-A09NA Service Manual page 27

OPERATING PROCEDURE
4. Removing the horizontal vane motor unit
(1) Remove the horizontal vane, the panel (refer to 1.) and the
corner box.
(2) Remove the screws of the horizontal vane motor unit, and
pull out the horizontal vane motor unit. (Photo 7)
(3) Disconnect the connector from the horizontal vane motor
unit.
5. Removing the indoor fan motor and the line flow fan
(1) Remove the horizontal vane, the panel (refer to 1.) and the
corner box.
(2) Remove the switch holder and the electrical box. (Refer to 3.)
(3) Remove the drain hose from the nozzle assembly, and
remove the nozzle assembly.
(4) Remove the screws fixing the motor bed. (Photo 8)
(5) Loosen the screw fixing the line flow fan. (Photo 9)
(6) Remove the motor bed together with fan motor and motor
band.
(7) Release the hooks of the motor band, and remove the
motor band then pull out the indoor fan motor.
(8) Remove the screws fixing the left side of the heat exchang-
er. (Photo 10)
(9) Lift the heat exchanger, and pull out the line flow fan to the
lower-left.
Photo 7
Photo 8
Screws of
the motor
bed
Photo 9
Screw of
the line flow
fan
Photo 10
Screws of the
left side of the
heat exchanger
27
PHOTOS
Screws of the
horizontal vane
motor unit
Motor band